General Information
Revision date
2015-05-09
Product name
1257 PART A
Emergency telephone
1-800-535-5053 USA
Icons in SDS
Company Information
company name
POLYGEM INC
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H315, H317, H319
Hazard statements
Code
Statements
H315
Causes skin irritation
Section 2
Classification according to GHS
Skin irritation: Category 2, H315 Skin Sensitization Category 1 H317 Eye irritation: Category 2, H319
Signal word
See SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION for personal protective
Hazard statements
H315 Causes skin irritation H315 Causes skin irritation H317 May cause an allergic skin reaction. H319 Causes serious eye irritation.
Response
P261 Avoid breathing mist/vapors/spray P264 Wash hands thoroughly after handling. P273 Avoid release to the environment. P280 Wear protective gloves, clothing, and eye/face protection. P302 + P352 IF ON SKIN: wash with plenty of soap and water P305+P351+P338 IF IN EYES Rinse cautiously with water for several minutes Remove contact lenses, if present and easy to do. Continue rinsing. P333+P313 If skin irritation or rash occurs: Get medical attention. P337+P313 If eye irritation persists: Get medical attention. P362+P364 Take off contaminated clothing and wash it before reuse. P391 Collect spillage.
Storage
Not applicable (CONTINUED)
Disposal
P501 Dispose of contents and containers in accordance with local, regional and international regulations.
Precautionary statements
are listed according to the United Nations Globally Harmonized System of Classification and Labeling of Chemicals (GHS) – Annex III
HMIS® ratings
CHEMICAL NAME HEALTH 2 FLAMMABILITY 1
Physical hazards
0 PERSONAL PROTECTION F See SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION for personal protective equipment recommendations.
Potential health effects
Eye contact: Mild or moderate irritation, possible minor temporary cornea injury. Skin contact: May cause skin irritation on prolonged or repeated exposure. Skin absorption: Not considered toxic. Inhalation: May cause nasal irritation, central nervous system depression or lung injury.
Potential chronic health
of over exposure None
OSHA HCS Classification
This product is classified as hazardous as defined within the GHS OSH Hazard Communication Standard 29CFR1910 1200 Chemical Name CAS # OSHA PEL* ACGIH TLV* WT% Bisphenol A Epoxy Resin 25068-36-6 N/E Dry Fillers 14808-60-7 N/E GHS/CLP: Skin irrt. 2 - H315; Skin Sens. 1 - H3117; Eye Irrt. 2 - H319 *ALL INGREDIENTS ARE REGISTERED ON TSCA. *Unless otherwise noted, all PEL and TLV Values are reported as 8 hour time weighted averages (TWA) Section 4 - FIRST AID MEASURES Description of First Aid Measures General advice: consult a physician; show this SDS to doctor in attendance. In the event of skin contact: Drench the affected area immediately with plenty of water: Remove contaminated clothing. Wash thoroughly with soap and water for at least 15 minutes Seek medical attention if irritation, rash of other adverse effects occur. In the event of eye contact: Bathe the eye with running water for at least 15 minutes, lifting the upper and lower eye lids. Get medical attention if symptoms persist. In the event of exposure by inhalation: Move person to fresh air. Get medical attention if symptoms develop Most important symptoms and effects both acute and delayed Skin irritation, allergic reactions. Indication of immediate medical attention and special treatment needed No specific antidote; treat symptomatically Eye wash stations and emergency showers should be available. Section 5 - FIRE FIGHTING MEASURES Recommended Extinguishing Media: Foam, carbon dioxide, dry chemicals or fog. Use water spray to cool fire exposed containers. Do not use direct water stream which may spread fire. Special Fire Fighting Procedures: Firefighters should wear protective goggles and self contained breathing apparatus to avoid inhalation of smoke or vapors. Remove all ignition sources. Unusual Fire or Explosion Hazards Exposure to decomposition products may be harmful to health; combustion products may include but are not limited to: carbon monoxide, carbon dioxide, phenolics, aldehydes; smoke may contain particles of the original material as well. Prevent fire-fighting waters from entering sewer or waterways. Advice for fire fighters: Use protective fire fighting clothing and positive pressure selfcontained breathing apparatus to protect against potential harmful and/or irritating fumes. Do not use high volume water jet as this may spread the area of the fire. additional eye protection such as chemical splash goggles and/or face shield when the possibility exits for eye contact with splashing or spraying liquid, or airborne material; Have an eye wash station available. Skin and Body Protection: Avoid skin contact by wearing chemically resistant gloves and long sleeved shirt. An apron may be appropriate if splashing can occur. Section 9: Physical and Chemical Properties Physical state: Gel Color: White Odor: Aromatic Odor Weight by gallon: 9.8 Solids (% by weight) 100 V.O.C. 0 g/L Boiling range: 280 F Melting point: N/A Density: 1.2 Percent volatile: 0 by Weight Vapor density (air=1): Heavier than air Vapor pressure (mm Hg): N/A Evaporation rate: N/A Water miscibility: Limited Section 10: Stability and Reactivity Stability: Stable Incompatibility: Strong Oxidizers, acids, bases and epoxy hardeners under controlled conditions. Hazardous polymerization: Will not occur. Hazardous decomposition products: Carbon Monoxide, Carbon Dioxide, smoke. Others Unknown.