Note: Ingredients listed on restricted chemical lists
EC/CAS
75-37-6
Name of the chemical
1,1-Difluoroethane
Concentration
50-60
EC/CAS
110-54-3
Name of the chemical
n-Hexan (790/2009)
Concentration
10-20
EC/CAS
63148-62-9
Name of the chemical
polydimethylsiloxane (Mw > 6 800 Da)
Concentration
1-10
General Information
Version
2.01
Revision date
2018-03-12
Product name
S-124 PARTING AGENT SIL.SPRAY
1.2.1 Relevant identified uses
and restrictions on use
1.2.2. Uses advised against
None
supplier name
silicone spray
Manufacturer Name
Plastic Process Equipment, Inc
Emergency telephone
1-800-262-8200
Icons in SDS
Company Information
company name
Plastic Process Equipment, Inc
GHS Information
Signal word
DANGER
Hazard Codes
Hazard statements (CLP)
H223, H229, H336
Hazard statements
Code
Statements
H223
Flammable aerosol
Section 2
SECTION 2: Hazards identification
Classification Skin corrosion/irritation Category 2 Reproductive Toxicity Category 2 Specific target organ toxicity (single exposure) Category 3 Specific target organ toxicity (repeated exposure) Category 2 Aspiration toxicity Category 1 Flammable aerosols Category 1 Gases under pressure Compressed Gas
2.2 Label elements
Emergency Overview DANGER
Hazard statements
Causes skin irritation Suspected of damaging fertility or the unborn child May cause respiratory irritation. May cause drowsiness or dizziness. May cause damage to organs (Central Nervous System, Eyes, Peripheral Nervous System, Respiratory System, and Skin) through prolonged or repeated exposure. May be fatal if swallowed and enters airways Extremely Flammable Aerosol Contains gas under pressure; may explode if heated Appearance Clear Physical state Aerosol Odor Solvent
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves/protective clothing/eye protection/face protection. Wash face, hands and any exposed skin thoroughly after handling. Do not breathe dust/fume/gas/mist/vapors/spray. Use only outdoors or in a well-ventilated area Keep away from heat/sparks/open flames/hot surfaces.-No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use
Response
If exposed or concerned: Get medical advice/attention. Specific treatment (see first aid on this label) IF ON SKIN: Wash with plenty of soap and water. If skin irritation occurs: Get medical advice/attention Take off contaminated clothing and wash before reuse IF INHALED Remove person to fresh air and keep comfortable for breathing. IF SWALLOWED: Immediately call a poison center/doctor Do NOT induce vomiting.
Storage
Store locked up Store in a well-ventilated place. Keep container tightly closed. Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
2.3 Other hazards
None
Further information
0.000001% of the mixture consists of ingredient(s) of unknown toxicity.
2.1 Classification of the substance or mixture
Skin corrosion/irritation Category 2 Reproductive Toxicity Category 2 Specific target organ toxicity (single exposure) Category 3 Specific target organ toxicity (repeated exposure) Category 2 Aspiration toxicity Category 1 Flammable aerosols Category 1 Gases under pressure Compressed Gas