Note: Ingredients listed on restricted chemical lists
EC/CAS
68476-86-8
Name of the chemical
Petroleum gases, liquefied, sweetened
Concentration
50-60
EC/CAS
1717-00-6
Name of the chemical
Ethane, 1,1-dichloro-1-fluoro
Concentration
40-50
General Information
Revision date
2017-02-14
Product name
P-151 HI-LINE PAINTABLE MOLD RELEASE
1.2.1 Relevant identified uses
and restrictions on use
1.2.2. Uses advised against
None
supplier name
Silicone Spray
Manufacturer Name
Plastic Process Equipment, Inc
Emergency telephone
1-800-535-5053, 800-535-5053
Icons in SDS
Company Information
company name
Plastic Process Equipment, Inc
GHS Information
Signal word
DANGER
Hazard Codes
Hazard statements (CLP)
H223, H229, H280, H320
Hazard statements
Code
Statements
H223
Flammable aerosol
Section 2
SECTION 2: Hazards identification
Classification Serious eye damage/eye irritation Category 2B Flammable aerosols Category 2 Gases under pressure Compressed Gas
2.2 Label elements
Emergency Overview DANGER
Hazard statements
Causes eye irritation Flammable aerosol Contains gas under pressure; may explode if heated Appearance Clear Physical state Aerosol Odor Solvent
Prevention
Wash face, hands and any exposed skin thoroughly after handling Wear eye/face protection Keep away from heat/sparks/open flames/hot surfaces. — No smoking Do not spray on an open flame or other ignition source Pressurized container: Do not pierce or burn, even after use
Response
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention
Storage
Protect from sunlight. Store in a well-ventilated place Do not expose to temperatures exceeding 122°F (50°C)
2.3 Other hazards
None
Further information
0% of the mixture consists of ingredient(s) of unknown toxicity
2.1 Classification of the substance or mixture
Serious eye damage/eye irritation Category 2B Flammable aerosols Category 2 Gases under pressure Compressed Gas
