Note: Ingredients listed on restricted chemical lists
EC/CAS
108-88-3
Name of the chemical
Toluene
Concentration
30-40
EC/CAS
124-38-9
Name of the chemical
Carbon dioxide CO2
Concentration
1-10
EC/CAS
71-43-2
Name of the chemical
Benzol
Concentration
<0.1
General Information
Revision date
2019-01-31
Product name
MC 2000 NON CHLOR MOLD CLNR
1.2.1 Relevant identified uses
and restrictions on use
1.2.2. Uses advised against
None
supplier name
Mold Cleaner
Manufacturer Name
Plastic Process Equipment, Inc
Emergency telephone
1-800-535-5053
Icons in SDS
Company Information
company name
Plastic Process Equipment, Inc
GHS Information
Signal word
DANGER
Section 2
SECTION 2: Hazards identification
Classification Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2A Reproductive Toxicity Category 2 Specific target organ toxicity (single exposure) Category 3 Specific target organ toxicity (repeated exposure) Category 2 Aspiration toxicity Category 1 Flammable Aerosols Category 1 Gases under pressure Compressed Gas
2.2 Label elements
Emergency Overview DANGER
Hazard statements
Causes skin irritation. Causes serious eye irritation. Suspected of damaging fertility or the unborn child May cause respiratory irritation. May cause drowsiness or dizziness. May cause damage to organs (Central Nervous System, Respiratory System, Eyes, Skin, Ears, Kidney, Blood, Bone Marrow, and Liver) through prolonged or repeated exposure. May be fatal if swallowed and enters airways. Extremely Flammable Aerosol Contains gas under pressure; may explode if heated Appearance Clear Physical state Aerosol Odor Solvent
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves, protective clothing,eye protection,face protection. Wash face, hands and any exposed skin thoroughly after handling. Do not breathe dust, fume, gas, mist, vapors, spray. Use only outdoors or in a well-ventilated area. Keep away from heat, sparks, open flames, hot surfaces - No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use.
Response
If exposed or concerned: Get medical advice, attention. Specific treatment (see first aid on this label). IF IN EYES:Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice, attention IF ON SKIN: Wash with plenty of soap and water. If skin irritation occurs: Get medical advice, attention. Take off contaminated clothing and wash it before reuse. IF INHALED Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER or doctor, physician if you feel unwell. IF SWALLOWED: Immediately call a POISON CENTER, doctor, physician. Do NOT induce vomiting.
Storage
Store locked up. Store in a well-ventilated place. Keep container tightly closed. Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F
Precautionary statements
Disposal Dispose of contents, container to an approved waste disposal plant.
2.3 Other hazards
None
Further information
0% of the mixture consists of ingredient(s) of unknown toxicity.
2.1 Classification of the substance or mixture
Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2A Reproductive Toxicity Category 2 Specific target organ toxicity (single exposure) Category 3 Specific target organ toxicity (repeated exposure) Category 2 Aspiration toxicity Category 1 Flammable Aerosols Category 1 Gases under pressure Compressed Gas