picodent sockelsep

Hazard statements (CLP)

H225, H319, H336

Code

Statements

H225

Highly Flammable liquid and vapour

EU Classification

Directive 67/548/EEC or 1999/45/EC

R-phrase(s)

Flammable. Vapours may cause drowsiness and dizziness.

Hazard categories

Flammable liquid: Flam. Liq. 2 Serious eye damage/eye irritation: Eye Irrit. 2 Specific target organ toxicity - single exposure: STOT SE 3

Hazard statements

Highly flammable liquid and vapour. Causes serious eye irritation. May cause drowsiness or dizziness. H225 Highly flammable liquid and vapour. H319 Causes serious eye irritation. H336 May cause drowsiness or dizziness.

Hazardous Ingredients

2-Propanol (Isopropanol)

Signal word

Danger

Hazard pictograms

GHS02-GHS07

Precautionary statements

P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. P261 Avoid breathing spray. P280 Wear protective gloves/eye protection. P312 Call a POISON CENTER/doctor if you feel unwell. P337+P313 If eye irritation persists: Get medical advice/attention. P370+P378 In case of fire: Use Water mist/Water spray jet/Full water jet/Extinguishing powder/alcohol resistant foam/Carbon dioxide (CO2) to extinguish. P403+P233 Store in a well-ventilated place. Keep container tightly closed.

Supplemental label elements

Labelling according to Regulation (EC) No. 1272/2008 [CLP]

Other physicochemical hazards

See section 9 for physical and chemical properties. The vapour of the product is heavier than air and may accumulate below ground level, in pits, channels and basements in higher concentration. The accumulation in lowlying or closen rooms can cause increased danger of fire and explosion. Vapours can travel considerable distances to a source of ignition where they can ignite, flash back, or explode. Vapours of flammable solvents can accumulate in the gas phase of closed container, especially during heat treatment. Therefore keep away from fire and sources of ignition. This material can be ignited by heat, sparks, flames, or other sources of ignition (e.g., static electricity, pilot lights, mechanical/electrical equipment, and electronic devices such as cell phones, computers, calculators, and pagers which have not been certified as intrinsically safe). The product will be applied by spraying. In use may form flammable/explosive vapour-air mixture. Even after use and until complete evaporation of the flammable components, there is still a danger of an explosive steam-air mixture forming.

Potential health effects

See section 11 for toxicological information.

Environmental effects

See section 12 for environmental information.

Other hazards

Special danger of slipping by leaking/spilling product.

Results of PBT and vPvB assessment

See under section 12.5 - Results of PBT and vPvB assessment.