SEMI-SYNTHETIC HYDRAULIC SERIES

SECTION 2: Hazards identification

Eye Contact: May cause mild irritation upon immediate contact. Skin Contact: Prolonged or repeated contact may cause the removal of skin oils, possibly leading to irritation or dermatitis. Vapor inhalation under ambient conditions will not occur. The inhalation of vapors (generated at extremely high temperature only) or mist may cause a mild irritation of Inhalation: the mucous membranes of the upper respiratory tract. Harmful concentrations of mists and/or vapors are unlikely to occur through reasonable and customary use of this product. No acute or chronic effects expected. However, minute amounts aspirated into the Ingestion: lungs during ingestion or vomiting may cause mild to severe pulmonary injury. 4. EMERGENCY AND FIRST AID PROCEDURES Flush eyes with plenty of water for 15 minutes. If irritation persists, or if an infection After contact with eyes: develops, seek medical attention. Wash off with soap and plenty of water. Apply skin cream if necessary. Seek After contact with skin: medical attention if irritation or infection occurs. Remove contaminated clothing and wash before reuse. If overcome by product vapor heated to extreme temperatures, immediately move from exposure and get medical attention. If breathing is irregular, start resuscitation After Inhalation: or administer oxygen if available. If overexposed to mist, remove from further exposure until excessive mist condition subsides. After Ingestion: Do not induce vomiting. Get medical attention. Drink 1 or 2 glasses of water. Advice to doctor: Treat symptomatically. Petrochem, Inc. The information contained herein is believed to be accurate but all suggestions are made without Guarantee because the conditions of 6N999 Whispering Trail Road, St. Charles, IL 60175 actual use are beyond our control. Petrochem, Inc. disclaims all Phone (630) 513-6350 Fax (630) 513-8324 Liability incurred in connection with the use of this data or suggestions. Web www.petrochem1.com Email info@petrochem1.com Member of the American Baking Society 5. EXPOSURE CONTROLS Wear safety goggles if splashes may occur. Do not wear contact lenses when Eye Protection: using chemicals. Hand Protection: Wear chemical resistant gloves. Body Protection: Wear clean, body-covering clothing to minimize dermal exposure. Under normal conditions of use, no special ventilation is required; however, if Ventilation: vaporized or misted, use local exhaust if possible. No special respiratory protection is required. However, if product is overheated Respiratory Protection: beyond conditions of normal use, or misted, wear the appropriate NIOSH-approved respiratory protection. Other Protection Safety showers, eye wash fountains, and washing facilities should be readily Measures: available. 6. FIRE FIGHTING MEASURES Flash Point & Method: 400°F (COC) Lower Explosion Limit: N/Av Upper Explosion Limit: N/Av Extinguishing Media: Water spray, foam, dry powder, carbon dioxide (CO2) Empty metal containers retain product residue. Do not pressurize, cut, weld, drill, Unusual Fire and solder or expose container to heat, flame, sparks, or other sources of ignition: it Explosion Hazards: may explode, causing serious injury or death. Exposure to heat builds up pressure in container. Cool with water spray. If leak or spill has not ignited, use water spray to disperse any vapor and to flush Special Fire Fighting spills away from ignition sources. Use self-contained breathing apparatus for Procedures: enclosed or confined spaces or as otherwise needed. Do not use direct stream of water, material may float and re-ignite. 7. ACCIDENTAL RELEASE MEASURES If product leaks or is inadvertently spilled, eliminate ignition sources and isolate surrounding spill area with the proper containment system to prevent the spill from reaching waterways. Add absorbent and soak up the product. Collect product and absorbent, place in a chemical waste container for proper disposal. 8. HANDLING AND STORAGE Avoid contact with skin and remove soiled or soaked clothing. Wash hands with soap and water before eating drinking and/or smoking. Clean skin thoroughly after work and if necessary, apply skin cream. • Store product under normal temperature and pressure. • Store product away from heat sources and food products. 9. PHYSICAL AND CHEMICAL PROPERTIES Physical State: Liquid Appearance: Liquid Color: Light-Yellow Odor: Mild Hydrocarbon-like Boiling Point: N/Av Vapor Pressure (mm Hg.): N/Av Vapor Density (Air = 1): N/Av Solubility in Water: Insoluble Specific Gravity (H20 = 1): N/Av Evaporation Rate (Ether = 1): N/Av 10. STABILITY AND REACTIVITY 2 Stability Stable Conditions to avoid: Open flames and other sources of heat Materials to avoid: Strong oxidizing agents such as pure oxygen Hazardous decomposition products: Fumes, smoke, carbon monoxide and carbon dioxide