Note: Ingredients listed on restricted chemical lists
EC/CAS
25068-38-6
Name of the chemical
4,4'-Isopropylidenediphenol, oligomeric reaction products with 1-chloro-2,3-epoxypropane
Concentration
5-10%
EC/CAS
7779-90-0
Name of the chemical
Trizinc bis(orthophosphate)
Concentration
1-2.5%
EC/CAS
107-15-3
Name of the chemical
Ethylenediamine
Concentration
<1%
General Information
Revision date
2016-01-15
Product name
2K Epoxy - Rust Cure Primer
1.2.1 Relevant identified uses
Paintwork
Manufacturer Name
Peter Kwasny GmbH
Emergency telephone
352-323-3500
Icons in SDS
Company Information
company name
Peter Kwasny, Inc
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H222, H229, H315, H317, H319, H334, H351, H373
Hazard statements
Code
Statements
H222
Extremely flammable aerosol
Section 2
SECTION 2: Hazards identification
2.1 Classification of the substance or mixture
GHS02 Flame Flam. Aerosol 1 H222-H229 Extremely flammable aerosol. Pressurized container: May burst if heated. GHS08 Health hazard Resp. Sens. 1 H334 May cause allergy or asthma symptoms or breathing difficulties if inhaled. Carc. 2 H351 Suspected of causing cancer. STOT RE 2 H373 May cause damage to organs through prolonged or repeated exposure. GHS07 Skin Irrit. 2 H315 Causes skin irritation. Eye Irrit. 2A H319 Causes serious eye irritation. Skin Sens. 1 H317 May cause an allergic skin reaction.
2.2 Label elements
The product is classified and labeled according to the Globally Harmonized System (GHS). (Contd. of page 1)
Hazard pictograms
GHS02 GHS08
Signal word
Danger
Hazardous Ingredients
Epoxy resin with an average molecular weight of 700≤1200 ethylbenzene ethylenediamine
Hazard statements
Extremely flammable aerosol. Pressurized container: May burst if heated. Causes skin irritation. Causes serious eye irritation. May cause allergy or asthma symptoms or breathing difficulties if inhaled. May cause an allergic skin reaction. Suspected of causing cancer. May cause damage to organs through prolonged or repeated exposure.
Precautionary statements
Keep away from heat/sparks/open flames/hot surfaces. No smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use. Do not breathe dust/fume/gas/mist/vapors/spray. [In case of inadequate ventilation] wear respiratory protection. Wear protective gloves. Wear eye protection / face protection. Wash thoroughly after handling. Contaminated work clothing must not be allowed out of the workplace. Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. IF ON SKIN: Wash with plenty of water. If inhaled: If breathing is difficult, remove person to fresh air and keep comfortable for breathing. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If skin irritation or rash occurs: Get medical advice/attention. If eye irritation persists: Get medical advice/attention. If experiencing respiratory symptoms: Call a POISON CENTER/doctor. IF exposed or concerned: Get medical advice/attention. Get medical advice/attention if you feel unwell. Specific treatment (see on this label). Wash contaminated clothing before reuse. Take off contaminated clothing and wash it before reuse. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Store locked up. Dispose of contents/container in accordance with local/regional/national/international regulations.
Additional information
Without adequate ventilation, explosive atmosphere/gas mix may be created
Classification system
· NFPA ratings (scale 0 - 4) Health = 1 4 Fire = 4 1 3 Reactivity = 3 (Contd. of page 2) · HMIS-ratings (scale 0 - 4) HEALTH *1 Health = *1 FIRE 4 Fire = 4 REACTIVITY 3 Reactivity = 3
PBT Substances
Not applicable
vPvB Substances
Not applicable
