Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
EC/CAS
1333-86-4
Name of the chemical
carbon black
Concentration
N/A
EC/CAS
108-91-8
Name of the chemical
Cyclohexylamin (790/2009)
Concentration
N/A
General Information
Revision date
2016-07-12
Product name
ParPHorm 1800
Chemical name
Mixture of: Polydimethylsiloxane; silane compounds; Inorganic substances in powdered form
1.2.1 Relevant identified uses
Non-conductive, moisture cure, Form-In-Place (FIP), silicone elastomer sealing compound
1.2.2. Uses advised against
known
Manufacturer Name
Parker Hannifin Corp
Icons in SDS
Company Information
company name
Parker Hannifin Corp
e-mail address of the competent person responsible for the Safety Data Sheet
chomailbox@parker.com
GHS Information
Signal word
WARNING!
Section 2
SECTION 2: Hazards identification
OSHA defined hazards This material is classified as hazardous under OSHA regulations (29CFR 1910.1200) (Hazcom 2012).
Physical hazards
This mixture does not meet the classification criteria according to OSHA Hazcom 2012.
Health hazards
Skin corrosion/irritation - Category 2 Eye damage/irritation - Category 2A
Environmental hazards
Not currently regulated by OSHA, refer to Section 12 for additional information. OSHA defined hazards This mixture does not meet the classification criteria according to OSHA Hazcom 2012.
Signal word
WARNING!
Hazard statements
Causes skin irritation. Causes serious eye irritation. 5 - 7% of the mixture consists of ingredient(s) of unknown toxicity
Prevention
Wash hands and face thoroughly after handling. Wear protective gloves and eye/face protection.
Response
IF ON SKIN Wash with plenty of soap and water. If skin irritation occurs Get medical advice/attention. Take off contaminated clothing and wash it before reuse. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: get medical advice/attention.
Storage
None required according to OSHA Hazcom 2012.
Disposal
None required according to OSHA Hazcom 2012. Hazard(s) not otherwise No OSHA defined hazard classes.
Other hazards which do not result in classification
Toxic fumes, gases or vapors may evolve on burning. May react with water. During cure, vapors are released which may be harmful. Silicone compounds in this product release sec-butylamine and cyclohexylamine upon moisture curing. sec-butylamine and cyclohexylamine are harmful and corrosive. Upon completion of the curing process, these hydrolysis products are no longer released. Mild respiratory irritant. May cause gastrointestinal irritation. Environmental precautions: Avoid release to the environment. See ECOLOGICAL INFORMATION, Section 12.
Additional information
Use with adequate ventilation. Avoid contact with eyes, skin and clothing. Keep away from extreme heat and direct flame. Keep away from incompatibles. Protect from moisture.
