Note: Ingredients listed on restricted chemical lists
EC/CAS
7440-22-4
Name of the chemical
Silver
Concentration
N/A
EC/CAS
25068-38-6
Name of the chemical
4,4'-Isopropylidenediphenol, oligomeric reaction products with 1-chloro-2,3-epoxypropane
Concentration
N/A
General Information
Revision date
2016-12-02
Product name
CHO-SHIELD 571, Part A
Chemical name
Mixture of: Metal compounds; Epoxy resin; Esters; Ketones
1.2.1 Relevant identified uses
Two part conductive coating
1.2.2. Uses advised against
known
Manufacturer Name
Parker Hannifin Corp
Icons in SDS
Company Information
company name
Parker Hannifin Corp
e-mail address of the competent person responsible for the Safety Data Sheet
chomailbox@parker.com
GHS Information
Signal word
DANGER!
Section 2
SECTION 2: Hazards identification
OSHA defined hazards This material is classified as hazardous under OSHA regulations (29CFR 1910.1200) (Hazcom 2012).
Physical hazards
Flammable liquid - Category 2
Health hazards
Skin corrosion/irritation - Category 2 Eye damage/irritation - Category 2A Skin sensitization - Category 1 Specific target organ toxicity, single exposure - Category 3 (Respiratory irritation) Specific target organ toxicity, single exposure - Category 3 (Narcotic effects)
Environmental hazards
Not currently regulated by OSHA, refer to Section 12 for additional information. OSHA defined hazards This mixture does not meet the classification criteria according to OSHA Hazcom 2012.
Signal word
DANGER!
Hazard statements
Highly flammable liquid and vapor. Causes skin irritation. Causes serious eye irritation. May cause an allergic skin reaction. May cause respiratory irritation. May cause drowsiness or dizziness.
Prevention
Keep away from heat, sparks and open flame. - No smoking. Keep container tightly closed. Ground/Bond container and receiving equipment. Use explosion-proof electrical and ventilating equipment. Use only non-sparking tools. Take precautionary measures against static discharge. Avoid breathing vapors. Wash hands and face thoroughly after handling. Use only outdoors or in a well-ventilated area. Contaminated work clothing must not be allowed out of the workplace. Wear protective gloves and eye/face protection.
Response
IF ON SKIN Wash with plenty of soap and water. If skin irritation or rash occurs Get medical advice/attention. Take off contaminated clothing and wash it before reuse. If inhaled: Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER or doctor/physician if you feel unwell. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: get medical advice/attention. In case of fire, use dry chemical, CO2, or alcohol foam to extinguish.
Storage
Store in a well-ventilated place. Keep container tightly closed. Keep cool. Store locked up.
Disposal
Dispose of contents/container in accordance with local regulation. Hazard(s) not otherwise No OSHA defined hazard classes.
Other hazards which do not result in classification
Excessive heating above 50°C / 122°F may degrade the resin component. Toxic fumes, gases or vapors may evolve on burning. Inhalation of fumes may result in metal fume fever, a flu-like illness. May cause gastrointestinal irritation. Prolonged overexposure may cause slight liver and kidney effects, such as increased organ weights. Silver in the form of a finely divided dust may cause discoloration in contact with skin, and argyrosis in case of inhalation.
Additional information
Avoid contact with eyes, skin and clothing. Keep away from incompatibles.