Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
≥10-≤25
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
≤3
EC/CAS
14464-46-1
Name of the chemical
Cristobalit (s. u. TRGS 906)
Concentration
<1
General Information
Version
19.03
Revision date
2022-12-05
Product name
PRO CONSTRUCTOR MATE BLANCO
1.2.1 Relevant identified uses
Paint or paint related material
supplier name
Compañía Sherwin-Williams S.A. de C.V
Emergency telephone
Mexico 800-681-9531. Available 24 hours and 365 days per year
Icons in SDS
Company Information
company name
Compañía Sherwin-Williams S.A. de C.V
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H350, H372
Hazard statements
Code
Statements
H350
May cause cancer
Section 2
SECTION 2: Hazards identification
2.1 Classification of the substance or mixture
CARCINOGENICITY - Category 1A SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 1
Ingredient(s) with unknown acute toxicity
9.4% (oral), 9.4% (dermal), 9.4% (inhalation)
Signal word
Danger
Hazard statements
H350 - May cause cancer. H372 - Causes damage to organs through prolonged or repeated exposure. (lungs)
Precautionary statements
General : P103 - Read label before use. P102 - Keep out of reach of children. P101 - If medical advice is needed, have product container or label at hand.
Prevention
P201 - Obtain special instructions before use. P202 - Do not handle until all safety precautions have been read and understood. P280 - Wear protective gloves, protective clothing and eye or face protection. P260 - Do not breathe vapor. P270 - Do not eat, drink or smoke when using this product. P264 - Wash thoroughly after handling.
Response
P308 + P313 - IF exposed or concerned: Get medical advice or attention.
Storage
P405 - Store locked up.
Disposal
P501 - Dispose of contents and container in accordance with all local, regional, national and international regulations.
Supplemental label elements
Adequate ventilation required when sanding or abrading the dried film. If Adequate elements ventilation cannot be provided wear an approved particulate respirator (NIOSH approved). Follow respirator manufacturer's directions for respirator use. DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading or sanding of the dry film may release Crystalline Silica which has been shown to cause lung damage and cancer under long term exposure. Please refer to the SDS for additional information. Keep out of reach of children. Do not transfer contents to other containers for storage.
2.3 Other hazards
None known.
