Note: Ingredients listed on restricted chemical lists
EC/CAS
123-86-4
Name of the chemical
acetic acid, butyl ester
Concentration
N/A
EC/CAS
111-76-2
Name of the chemical
Ethylene glycol monobutyl ether (EGBE)
Concentration
N/A
EC/CAS
9004-70-0
Name of the chemical
Nitrocellulose
Concentration
N/A
General Information
Revision date
2015-08-27
Product name
Metal-Clad Industrial Enamel (Aerosol)
Manufacturer Name
P.F.I., Inc.
Emergency telephone
PERS 24-Hour Hotline: (800) 633-8253
Icons in SDS
Company Information
company name
P.F.I., Inc.
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H222, H280, H305, H317, H319, H335, H351, H361, H373
Hazard statements
Code
Statements
H222
Extremely flammable aerosol
H280
Contains gas under pressure; may explode if heated
H305
May be harmful if swallowed and enters airways
H317
May cause an allergic skin reaction
H319
Causes serious eye irritation
H335
May cause respiratory irritation
H351
Suspected of causing cancer
H361
Suspected of damaging fertility or the unborn child
H373
May cause damage to organs through prolonged or repeated exposure
Section 2
SECTION 2: Hazards identification
29 CFR 1910.1200) OSHA/HCS Status: This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR 1910.1200).
2.1 Classification of the substance or mixture
FLAMMABLE AEROSOLS – Category 1 GASES UNDER PRESSURE – Compressed Gas SERIOUS EYE DAMAGE/EYE IRRITATION – Category 2A SKIN SENSITIZATION – Category 1 CARCINOGENICITY – Category 2 TOXIC TO REPRODUCTION (UNBORN CHILD) – Category 2 SPECIFIC TARGET ORGAN TOXICITY (SINGLE EXPOSURE) – Category 3 SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) – Category 2
Aspiration hazard
Category 1
Signal word
Danger
Hazard statements
H222 Extremely flammable aerosol H280 Contains gas under pressure; may explode if heated H319 Causes serious eye irritation H317 May cause an allergic skin reaction H361 Suspected of damaging the unborn child H351 Suspected of causing cancer H305 May be harmful if swallowed and enters airways H335 May cause respiratory irritation H335 May cause drowsiness and dizziness H373 May cause damage to organs through prolonged or repeated exposure
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Use personal protective equipment as required. Wear protective gloves, eye protection, and face protection. Keep away from heat and hot surfaces, including sparks, open flames, and any other ignition sources. Do not smoke near or around this product. Use explosion-proof electrical, ventilation, lighting, and other material handling equipment. Use only non-sparking tools. Keep container tightly closed and use only outdoors or in well ventilated areas. Avoid static buildup and discharge. Avoid inhaling product vapors. Wash hands and any contaminated clothing thoroughly after handling.
Response
Seek medical attention if you feel unwell, or are concerned about exposure. IF INHALED: remove victim to fresh air and keep at rest in a position comfortable for breathing. IF SWALLOWED: contact a poison control center or physician immediately. Do not induce vomiting. IN CASE OF SKIN OR HAIR CONTACT: remove all contaminated clothing, and wash skin with soap and water. If irritation or rash occurs, get medical attention. IF IN EYES: rinse with copious amounts of water for several minutes. Remove contact lenses, if present and easy to do so. If eye irritation persists, seek medical attention.
Storage
Disposal Store in a locked and secure environment. Store in a cool, well ventilated area away from direct sunlight and heat. Dispose of contents and container in accordance with all local, regional, state, and federal regulations.
Supplemental label elements
Ensure adequate ventilation at all times when using this product and when sanding the Elements: dried film. Wear an appropriate, NIOSH approved particulate respirator. Follow all respirator manufacturer's directions for proper use. Abrading or sanding this product's dried film may release crystalline silica which has been shown to cause lung damage and may cause cancer following long term exposure. Rags, sandpaper, steel wool, and other abrading materials or waste containing this product may spontaneously combust when improperly disposed of. Product contains solvents which can cause permanent brain and nervous system damage. Intentional misuse by concentrating and inhaling the contents of this product can be harmful or fatal. Do not transfer contents to another container. PROPOSITION 65 WARNING: this product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. FOR INDUSTRIAL USE ONLY.
2.3 Other hazards
None known.