Metal-Clad High Sheen Cold Galvanizing Spray

Hazard statements (CLP)

H222, H280, H305, H317, H319, H335, H351, H361, H373

Code

Statements

H222

Extremely flammable aerosol

SECTION 2: Hazards identification

Signal word

Danger

Hazard statements

H222 Extremely flammable aerosol H280 Contains gas under pressure; may explode if heated H319 Causes serious eye irritation H317 May cause an allergic skin reaction H361 Suspected of damaging the unborn child H351 Suspected of causing cancer H305 May be harmful if swallowed and enters airways H335 May cause respiratory irritation H335 May cause drowsiness and dizziness H373 May cause damage to organs through prolonged or repeated exposure

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Use personal protective equipment as required. Wear protective gloves, eye protection, and face protection. Keep away from heat and hot surfaces, including sparks, open flames, and any other ignition sources. Do not smoke near or around this product. Use explosion-proof electrical, ventilation, lighting, and other material handling equipment. Use only non-sparking tools. Keep container tightly closed and use only outdoors or in well ventilated areas. Avoid static buildup and discharge. Avoid inhaling product vapors. Wash hands and any contaminated clothing thoroughly after handling.

Response

Seek medical attention if you feel unwell, or are concerned about exposure. IF INHALED: remove victim to fresh air and keep at rest in a position comfortable for breathing. IF SWALLOWED: contact a poison control center or physician immediately. Do not induce vomiting. IN CASE OF SKIN OR HAIR CONTACT: remove all contaminated clothing, and wash skin with soap and water. If irritation or rash occurs, get medical attention. IF IN EYES: rinse with copious amounts of water for several minutes. Remove contact lenses, if present and easy to do so. If eye irritation persists, seek medical attention.

Storage

Disposal Store in a locked and secure environment. Store in a cool, well ventilated area away from direct sunlight and heat. Dispose of contents and container in accordance with all local, regional, state, and federal regulations.

Supplemental label elements

Ensure adequate ventilation at all times when using this product and when sanding the Elements: dried film. Wear an appropriate, NIOSH approved particulate respirator. Follow all respirator manufacturer's directions for proper use. Abrading or sanding this product's dried film may release crystalline silica which has been shown to cause lung damage and may cause cancer following long term exposure. Rags, sandpaper, steel wool, and other abrading materials or waste containing this product may spontaneously combust when improperly disposed of. Product contains solvents which can cause permanent brain and nervous system damage. Intentional misuse by concentrating and inhaling the contents of this product can be harmful or fatal. Do not transfer contents to another container. PROPOSITION 65 WARNING: this product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. FOR INDUSTRIAL USE ONLY.

2.3 Other hazards

None known.

2.1 Classification of the substance or mixture

Classification of the FLAMMABLE AEROSOLS – Category 1 Substance: GASES UNDER PRESSURE – Compressed Gas SERIOUS EYE DAMAGE/EYE IRRITATION – Category 2A SKIN SENSITIZATION – Category 1 CARCINOGENICITY – Category 2 TOXIC TO REPRODUCTION (UNBORN CHILD) – Category 2 SPECIFIC TARGET ORGAN TOXICITY (SINGLE EXPOSURE) – Category 3 SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) – Category 2 ASPIRATION HAZARD – Category 1