Pipe Insulation with Facing

SECTION 2: Hazards identification

Regulatory Status This product is considered an article. 29 CFR 1910.1200(c) definition of an article is as follows "Article" means a manufactured item other than a fluid or particle (i) which is formed to a specific shape or design during manufacture; (ii) which has end use function(s) dependent in whole or in part upon its shape or design during end use; and (iii) which under normal conditions of use does not release more than very small quantities, e.g., minute or trace amounts of a hazardous chemical (as determined under paragraph (d) of this section), and does not pose a physical hazard or health risk to employees This product is considered an article per the Canadian Hazardous Products Regulation SOR/2015-17 Manufactured articles which meet the definition of the Canadian Hazardous Products Act (any article that is formed to a specific shape or design during manufacture, the intended use of which when in that form is dependent in whole or in part on its shape or design, and that, when being installed, if the intended use of the article requires it to be installed, and under normal conditions of use, will not release or otherwise cause an individual to be exposed to a hazardous product) are not regulated by the Canadian Hazardous Products Regulation SOR/2015-17

Further information

May cause temporary skin and mucous membranes itching due to the mechanical abrasion effect of fibers