Coated Veils

SECTION 2: Hazards identification

29 CFR 1910.1200) OSHA Regulatory Status This chemical is not considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200). This product is considered an article. 29 CFR 1910.1200(c) definition of an article is as follows "Article" means a manufactured item other than a fluid or particle (i) which is formed to a specific shape or design during manufacture; (ii) which has end use function(s) dependent in whole or in part upon its shape or design during end use; and (iii) which under normal conditions of use does not release more than very small quantities, e.g., minute or trace amounts of a hazardous chemical (as determined under paragraph (d) of this section), and does not pose a physical hazard or health risk to employees WHMIS Regulatory Status This product is not considered hazardous by the Canadian Hazardous Products Regulation SOR/2015-17 Continuous Filament Glass Fiber (CFGF) Products are manufactured articles. The definition of manufactured article given by the Canadian Hazardous Products Act R.S.C., 1985, c. H-3 is: any article that is formed to a specific shape or design during manufacture, the intended use of which when in that form is dependent in whole or in part on its shape or design, and that, when being installed, if the intended use of the article requires it to be installed, and under normal conditions of use, will not release or otherwise cause an individual to be exposed to a hazardous product

2.2 Label elements

The product contains no substances which at their given concentration, are considered to be hazardous to health

2.3 Other hazards

Not applicable (HNOC)

Further information

As manufactured continuous filament glass fibers are non-respirable. May cause temporary skin and mucous membranes itching due to mechanical abrasion effect of fibers. Under normal conditions of use, these products may release dust and non-respirable fibers (Particles Not Otherwise Regulated). Under severe process conditions (e.g. shredding, crushing), these products may release very small amount of respirable particulate, some of which may be fiber-like in terms of l/d ratio (so-called "shards"). See Section 8 for Exposure Limit Data Under severe processing conditions (e.g. cutting or grinding), these products may release trace amount of airborne crystalline silica dust, part of which may be respirable. See Section 8 for Exposure Limit Data. Unknown acute toxicity • 67.1% of the mixture consists of ingredient(s) of unknown toxicity