Talamar Extreme LTE

SECTION 2: Hazards identification

mineral oil, Prolonged or repeated skin contact can cause mild irritation and inflammation characterized by drying, cracking, (dermatitis) or oil acne. Repeated or profonged inhalation of petroleum-based mineral oif mists at concentrations above applicable workplace exposure ievels can cause respiratory irritation or other pulmonary effects. Qs Unknoi No data available Nat applicable

Hazard statements

see section 16 11/19/2013 EN (English) Page 1 according to the federal final rule of hazard communication revised on 2012 (HazCom 2012) Poly long-chain aikyl methacrylate 4-3 . 2A, H319 Ne Of first ai ; en ne First-aid measures general Never give anything by mouth to an unconscious person. ff you feel unwell, seek medical advice (show the label where possible). First-aid measures after inhalation Assure fresh air breathing. Allow the victim to rest. In case of breathing difficulties administer oxygen. in all cases of doubt, or when symptoms persist, seek medical advice. First-aid measures after skin contact Remove affected clothing and wash all exposed skin area with mild soap and water, followed by warm water rinse. If skin irritation occurs: Get medical advice/attention. First-aid measures after eye contact incase of contact with eyes, rinse immediately with plenty of flowing water for 10 to 15 minutes holding eyelids apart. Subsequently consult an ophthalmologist. Obtain medical attention if pain, blinking or redness persist. First-aid measures after ingestion Immediately calla POISON CENTER or doctor/physician. it and effects, both acute and delaye Symptoms/injuries This product contains a petroleum-based mineral oil. Prolonged or repeated skin contact can cause mild irritation and inflammation characterized by drying, cracking, (dermatitis) or oil acne. Repeated or prolonged inhalation of petroleum-based mineral oil mists at concentrations above applicable workplace exposure fevels can cause respiratory irritation or other pulmonary effects. Symptoms/injuries after inhaiation Excess inhalation might cause risk of chemicals pneumonitis. Symptoms/injuries after skin contact Frequent or prolonged contact with skin may cause dermal irritation. Symptoms/injuries after eye contact Oil Mist. Contact may cause eye irritation. 43. icatio y immedi: No additional information available B inguis! mec Suitable extinguishing media Use media as appropriate for surrounding materiat . Foam. Dry powder. Carbon dioxide. Water spray. Sand. Unsuitable extinguishing media Do not use a heavy water stream. 5. ards n Fire hazard When heated above the flash point, releases vapours. Gas/vapours, flammable. 53 dvic ‘etighté'

Precautionary statements

fire Stop and contain spill/release if it can be done safely. If this cannot be done, ailow fire to burn under control. Gases/vapours, toxic. Firefighting instructions Use water spray or fog for cooling exposed containers. Exercise caution when fighting any chemical fire. Prevent fire-fighting water from entering environment. Protective equipment for firefighters Do not enter fire area without proper protective equipment, including respiratory protection. Wear self-contained respiratory apparatus during longer or intensive exposition or spraying processing,

Further information

Special danger of slipping by leaking/spilling product. 6. a Per 4 General measures Special danger of slipping by leaking/spilling product. Stop leak if safe to do so. Relevant water authorities should be notified of any large spillage to water course or drain. Take any precaution to avoid mixing with combustibles ... Emergency procedures Evacuate unnecessary personnel. Avoid breathing mist or vapor . Avoid direct eye contact with product, also via contamination on hands. Avoid contact with skin, eyes and clothes. For emergency responders Protective equipment Equip cleanup crew with proper protection. Emergency procedures The low volatility of this product does not require ventilation. However depending on the condition an adequate ventalation might be required. s if liquid enters sewers or public waters. Soak up spills with inert solids, such as fabric absorbents, clay or diatomaceous earth as soon as possible. Collect spillage. Store away from other materials, Consult the appropriate authorities about waste disposai. 11/49/2013. EN (English) 216 according to the federal final rufe of hazard communication revised on 2012 (HazCom 2012) 6 sf ( See Heading 8. Exposure controls and personal protection. Additional hazards when processed Special danger of slipping by feaking/spilling product. Precautions for safe handling Provide good ventilation in process area to prevent formation of vapour. Avoid contact with skin, eyes and clothes. Personal protective equipment should be selected based upon the conditions under which this product is handled or used. Avoid breathing dust/fume/gas/mist/vapours/spray. Empty container retains product residue. Wash hands and other exposed areas with mild soap and water before eating, drinking or smoking and when leaving work. Hygiene measures Contaminated work clothing should not be allowed out of the workplace. Wash contaminated clothing before reuse. Do not eat, drink or smoke when using this product. patibilitie Technical measures Technical ventitation of workplace. Ensure the ventilation system is regularly maintained and tested. Emergency shower installed. A washing facilityAwater for eye and skin cleaning purposes should be present. Storage conditions Keep container closed when not in use. Keep only in the original container in a cool, well- ventilated place away from highly flammable substances. Incompatible materials sawdust. Strong acid. Base. Oxidizing agents. Storage temperature Store at ambient temperature Heat and ignition sources. Remove ali sources of ignition. Storage area Protect against direct sunlight. pee use(s) No additional information available Appropriate engineering controls Awashing facility/water for eye and skin cleaning purposes should be present. Emergency shower installed. Mechanical ventilation should be used in tow or enclosed places. Personal protective equipment Personal protective equipment should be selected based upon the conditions under which this product is handled or used. Avoid all unnecessary exposure. Gloves. Protective clothing. Protective goggles, Hand protection Wear protective gloves, rubber gloves. Eye protection Wear chemical splash goggle. Chemical goggles or safety glasses. Skin and body protection Chemical resistant suit. Wear rubber boots. Respiratory protection Wear respiratory protection. Thermal hazard protection Wear a self-contained breathing apparatus and appropriate personal protective equipment (PPE). Environmental exposure controis Do not allow run-off from fire-fighting to enter drains or water courses. Ensure waste is collected and contained. Notify authorities if product enters sewers or public waters. Do not eat, drink or smoke during use. Physical state 2 Liquid Colour Clear Blue. Odour Petroleum. Characteristic. Odour threshoid No data available pH No data available Relative evaporation rate (butylacetate=1) No data available Melting point No data available Freezing point No data available Boiling point No data available Flash point 191°C 375 °F Self ignition temperature No data available 41/19/2013 EN (English) 3G according to the federal final rule of hazard communication revised on 2012 (HazCom 2042) Decomposition temperature No data available Flammability (solid, gas) No data available Vapour pressure Negligible vapour pressure at ambient conditions Relative vapour density at 20 °C > 10 Relative density 0.849 g/cm? at 15.6 °C (104 °F} Solubility Water: < 0.1% insalubie Organic solvent:completely soluble Log Pow No data available Log Kow 1>4 Viscosity, kinematic + 18 cSt at 40°C (104 °F) Viscosity, dynamic No data available Explosive properties No data availabie Oxidising properties No data available Explosive limits. No data available therints lor No additional information available 10. tabilit Hazardous polymerisation does not occur. AO. sSiDH Not established. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose containers to flames, sparks, heat, or other potential ignition sources. 10. incompatible materials: Strong acid. Strong bases. sawdust, Oxidizing agents, strong. zard nposi Fume. Carbon monoxide. Carbon dioxide. Acute toxicity Not Classified Skin corrosionfirritation Not classified Serious eye damage/irritation Not classified Respiratory or skin sensitisation Not classified Germ ceil mutagenicity Not classifiedBased on available data, the classification criteria are not met Carcinogenicity Not classified Reproductive toxicity Not classifiedBased on available data, the classification criteria are not met Specific target organ toxicity (single exposure) Not classified Specific target organ toxicity (repeated Not classifiedBased on available data, the classification criteria are not met exposure)

Aspiration hazard

Not classified Potential Adverse human health effects and Based on available data, the classification criteria are not met. symptoms Symptomsj/injuries after inhalation Excess inhalation might cause risk of chemicals pneumonitis. Symptoms/injuries after skin contact Frequent or prolonged contact with skin may cause dermal irritation. Symptoms/injuries after eye contact Oi mist contact may cause eye irritation. Ecology - general May be toxic to aquatic life, Ce LC50 fishes > §000 mg/l (Exposure time: 96 - Species; Oncorhynchus mykiss) 14/49/2013 EN ngtish) AG according to the federal final nde of hazard communication revised on 2012 (HazCom 2012) C50 Daphnia > 1000 mgd (Exposure time: 48 - Species: Daphnia magna) -Northlan mat Extreme Persistence and degradability Not established. Log Kow Bioaccumulative potential Not established. Avoid release to the environment. 43:4 Aste treatmel od: Waste disposal recommendations Dispose in a safe manner in accordance with local/national regulations. Liquid product may not be disposed of with household waste or landfilled, Do not allow to enter into drains/waters or in the soil. Ecology - waste materials Avoid release to the environment. Hazardous waste due to toxicity. SECTION 14; sport informatic In accordance with ADR / RID / IMDG / TATA / ADN 44. Not applicable 46. IN proper Shipping Not applicable dditional informatio Other information No supplementary information available. Overland transport No additional information available Tre sport by sae No additional information available tillates r ve) i Bi 4742-65 Listed on the United States TSCA (Toxic Substances Control Act) inventory ) inventory. EU-Ragulations ‘Distillates eum jeway parattir 65 Listed on the EEC inventory EINECS (European inventory of Existing Commercial Chemical Substances) substances. ation according to £ 2008 [CLP] Not classified 14/19/2013 EN (English) 5/6 according to the federal final rule of hazard communication revised on 2012 (HazCom 2012) Sor IS9WASIED WH eecording to Directive 67/548 Not classified National regulations istillates, petrol olvent-dewaxed heavy paraffinic (6474: Listed on the AICS (the Austrafian inventory of Chemical Substances) Listed on Inventory of Existing Chemical Substances (IECSC) Listed on the Japanese ENCS (Existing & New Chemicals Substances) inventory. Listed on the Korean ECL (Existing Chemical List) inventory. Listed on New Zealand - Inventory of Chemicals (NZIoC) Listed on Inventory of Chemicals and Chemical Substances (PICCS) Distillates, U.S. - Texas - Effects Screening Levels - Long Term U.S. - Texas - Effects Screening Levels - Short Term Other information None. Full text of H-phrases: see section 16: Aquatic Acute Hazardous to the aquatic environment — AcuteHazard, Category 1 Aquatic Chronic 1 Hazardous to the aquatic environment — Chronic Hazard, Category 4 Aquatic Chronic 2 Hazardous to the aquatic environment — Chronic Hazard, Category 2 Aquatic Chronic 3 Hazardous to the aquatic environment — Chronic Hazard, Category 3