Note: Ingredients listed on restricted chemical lists
EC/CAS
7727-37-9
Name of the chemical
Nitrogen N2
Concentration
99.9001-99.9999%
General Information
Version
3
Revision date
2019-02-27
Product name
0.0001% to 0.0999% Hydrogen Sulfide in Nitrogen
Product Synonyms
Hydrogen Sulfide in Nitrogen
Chemical name
Gas Mixture
1.2.1 Relevant identified uses
Calibration of analyitical instrumentation
supplier name
NorLab a division of Norco
Icons in SDS
Company Information
company name
NorLab a division of Norco
GHS Information
Signal word
WARNING
Section 2
SECTION 2: Hazards identification
GHS Classification in Accordance with 29 CFR 1910 (OSHA HCS): Classification of Substance
Signal word
WARNING
Hazard statements
H280 - Contains gas under pressure; may explode if heated H333 - May be harmful if inhaled OSHA-H01 - MAY DISPLACE OXYGEN AND CAUSE RAPID SUFFOCATION
Precautionary statements
P202 - Do not handle until all safety precautions have been read and understood. P251 - Pressurized container: Do not pierce or burn, even after use. P261 - Avoid breathing dust/fume/gas/mist/vapors/spray. P271 - Use only outdoors or in a well-ventilated area. P281 - Use personal protective equipment as required. P304+340 - IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. P308+313 - IF exposed or concerned: Get medical advice/attention. P403+233 - Store in a well ventilated place. Keep container tightly closed. CGA-PG02 - Protect from sunlight when ambient temperature exceeds 52 °C (125 °F). CGA-PG05 - Use a back flow preventive device in the piping. CGA-PG06 - Close valve after each use and when empty. CGA-PG10 - Use only with equipment rated for cylinder pressure. CGA-PG20 - Use only equipment of compatible materials of construction.
2.3 Other hazards
Inhalation Lethal concentrations of hydrogen sulfide cause respiratory paralysis and breathing stops. Life threatening pulmonary edema is common following prolonged exposure to concentrations between 250 and 600 ppm. Edema has been reported following prolonged exposure at concentrations as low as 50 ppm. Sense of smell becomes rapidly fatigued and cannot be used as warning of exposure. Skin Contact Contact with hydrogen sulfide in this product may cause severe pain itching and erythema. Contact with rapidly expanding gas near the point of release may cause frostbite with redness, skin color change to gray or white, and blistering. Eye Contact Exposure to 20-50 PPM hydrogen sulfide will cause eye irritation. Low to moderately high concentrations may cause painful conjunctivitis, photophobia, lacrimation and corneal opacity. Exposure to 50-100 PPM hydrogen sulfide has resulted in temporary damage to the corneal epithelium in dogs, cats, rabbits, and guinea pigs. Contact with rapidly expanding gas near the point of release may cause frostbite. Ingestion Not anticipated. Product is a gas at normal conditions.
2.1 Classification of the substance or mixture
GHS Classification in Accordance with 29 CFR 1910 (OSHA HCS): Physical, Gases Under Pressure, Compressed Gas