NEUTRAL BOMAR

SECTION 2: Hazards identification

1272/2008 Flash point. Information not available. This document must not be regarded as a guarantee on any specific product property. GENERAL INFORMATION > 60 °C. Use jets of water to cool the containers to prevent product decomposition and the development of substances potentially hazardous for Evaporation Rate The use of this product is not subject to our direct control; therefore, users must, under their own responsibility, comply with the current health Not available.

Results of PBT and vPvB assessment

health. Always wear full fire prevention gear. Collect extinguishing water to prevent it from draining into the sewer system. Dispose of Flammability of solids and gases and safety laws and regulations. The producer is relieved from any liability arising from improper uses. Not available.

2.1 Classification of the substance or mixture

contaminated water used for extinction and the remains of the fire according to applicable regulations. Lower inflammability limit. Information not available. Not available. SPECIAL PROTECTIVE EQUIPMENT FOR FIRE-FIGHTERS Upper inflammability limit. Not available.

Other hazards

The product is not classified as hazardous pursuant to the provisions set forth in Directives 67/548/EEC and 1999/45/EC and/or EC Hardhat with visor, fireproof clothing (fireproof jacket and trousers with straps around arms, legs and waist), work gloves (fireproof, cut proof Lower explosive limit. The product is not classified as hazardous pursuant to the provisions set forth in Directives 67/548/EEC and 1999/45/EC and/or EC Not available. Regulation 1272/2008 (CLP) (and subsequent amendments and supplements). and antistatic), a depressurised mask with facemask covering the whole of the operator’s face or a self-respirator (self-protector) in the event Upper explosive limit. Information not available. Regulation 1272/2008 (CLP) (and subsequent amendments and supplements). Not available. of large quantities of fume. Vapour pressure. Not available.

2.2 Label elements

13. Disposal considerations. Vapour density Not available. 6. Accidental release measures. Specific gravity. Not available. 13.1. Waste treatment methods.

Hazard pictograms

Solubility -- soluble in water 6.1. Personal precautions, protective equipment and emergency procedures. Partition coefficient: n-octanol/water Reuse, when possible. Neat product residues should be considered special non-hazardous waste. Not available.

Signal word

Eliminate all sources of ignition (cigarettes, flames, sparks, etc.) from the leakage site. If there are no contraindications, spray solid products Ignition temperature. Disposal must be performed through an authorised waste management firm, in compliance with national and local regulations. -- Not available. with water to prevent the formation of dust. Use breathing equipment if fumes or powders are released into the air. Block the leakage if there Decomposition temperature. CONTAMINATED PACKAGING Not available.

Hazard statements

is no hazard. Do not handle damaged containers or the leaked product before donning appropriate protective gear. For information on risks Viscosity Contaminated packaging must be recovered or disposed of in compliance with national waste management regulations. -- Not available. for the environmental and health, respiratory tract protection, ventilation and personal protection equipment, see the other sections of this Reactive Properties Not available. 14. Transport information.

Precautionary statements

sheet. These indications apply for both processing staff and those involved in emergency procedures. --

Further information

The classification of the compound, featuring an extreme pH value, is based on the results of an appropriate validated in-vitro test as set out 6.2. Environmental precautions. in the 67/548/EEC directive, annex VI, paragraph 3.2.5, and following modifications. The product is not dangerous under current provisions of the Code of International Carriage of Dangerous Goods by Road (ADR) and by Rail in the 67/548/EEC directive, annex VI, paragraph 3.2.5, and following modifications. The product must not penetrate the sewers, surface water, ground water and neighbouring areas. Information not available. (RID), of the International Maritime Dangerous Goods Code (IMDG), and of the International Air Transport Association (IATA) regulations.

2.3 Other hazards

6.3. Methods and material for containment and cleaning up. 10. Stability and reactivity. 15. Regulatory information. Use inert absorbent material (sand, vermiculite, diatomeous earth, Kieselguhr, etc.) to soak up leaked product. Collect the majority of the 10.1. Reactivity. Information not available. remaining material and deposit it in containers for disposal. If there are no contraindications, use jets of water to eliminate product residues. Information not available. 15.1. Safety, health and environmental regulations/legislation specific for the substance or mixture. Make sure the leakage site is well aired. Contaminated material should be disposed of in compliance with the provisions set forth in point 13. There are no particular risks of reaction with other substances in normal conditions of use.