Note: Ingredients listed on restricted chemical lists
EC/CAS
7732-18-5
Name of the chemical
Water, distilled, conductivity or of similar purity H2O
Concentration
48-52 45-55
EC/CAS
75-01-4
Name of the chemical
Chloroethylene
Concentration
<0.03%
General Information
Revision date
2015-12-20
Product name
VINYBLAN 603
Chemical name
Colloidal dispersion of PVC copolymer in water
1.2.1 Relevant identified uses
This product is intended for use in inks, coatings, adhesives and sealants
supplier name
Shin-Etsu MicroSi, Inc
Manufacturer Name
Nissin Chemical Industry Co., Ltd
Emergency telephone
(800) 424-9300
Icons in SDS
Company Information
company name
Nissin Chemical Industry Co., Ltd
e-mail address of the competent person responsible for the Safety Data Sheet
csteam@microsi.com
Section 2
SECTION 2: Hazards identification
Hazard categories
Not Applicable. This product does not meet the physical, health, or environmental classification criteria of GHS (Globally Harmonized System).
2.3 Other hazards
Wear protective gloves/protective clothing/eye protection/face protection. Store in a closed container. Dispose of contents/container Follow the waste disposal requirements of your country, state, or local authorities. <55 % of mixture consists of ingredients of unknown acute toxicity
2.1 Classification of the substance or mixture
FIRE AND EXPLOSION Not Hazardous Not considered flammable or combustible. APPEARANCE White liquid
NFPA Ratings
Component Health Flammability Instability Special (Blue) (Red) (Yellow) (White) VINYBLAN 603 1 0 0 -- SAFETY NOTICE—VINYL CHLORIDE EXPOSURE The manufacturing process of Vinyblan products results in residual Vinyl Chloride (VC) being contained in the product. During shipment, the exposure of this product to ambient temperatures causes the residual VC to volatilize and accumulate within the shipping container. Vinyl Chloride has both a very low flash point (-108 °F) and boiling point (7 °F). Ambient air testing has been conducted to determine the initial concentration of VC that an employee may be exposed to when opening the container doors prior to unloading the product.
