Note: Ingredients listed on restricted chemical lists
EC/CAS
200-659-6/67-56-1
Name of the chemical
Methanol
Concentration
≥97 <1.0
EC/CAS
200-831-0/75-01-4
Name of the chemical
Chloroethylene
Concentration
<0.005%
General Information
Revision date
2016-06-27
Product name
SOLBIN A
Product Synonyms
Vinylchloride-Vinylacetate Based Copolymer
Chemical name
Vinylchloride-Vinylacetate Based Copolymer
1.2.1 Relevant identified uses
This product is intended for use as an additive for coatings, inks, paints, and adhesives
supplier name
Shin-Etsu MicroSi, Inc
Manufacturer Name
Nissin Chemical Industry Co., Ltd
Emergency telephone
(800) 424-9300
Icons in SDS
Company Information
company name
Nissin Chemical Industry Co., Ltd
e-mail address of the competent person responsible for the Safety Data Sheet
csteam@microsi.com
GHS Information
Signal word
Warning
Section 2
SECTION 2: Hazards identification
Hazard categories
Combustible Dust (No Pictogram)
Signal word
Warning
Hazard statements
May form combustible dust concentrations in air
2.3 Other hazards
Keep away from all ignition sources including heat, sparks, and flame. Prevent dust accumulation (to minimize explosion hazard) <0 % of mixture consists of ingredients of unknown acute toxicity.
2.1 Classification of the substance or mixture
FIRE AND EXPLOSION Not Hazardous May form flammable / explosive dust-air mixture. APPEARANCE Pale yellow fine powder
NFPA Ratings
Component Health Flammability Instability Special (Blue) (Red) (Yellow) (White) SOLBIN A 1 0 0 -- SAFETY NOTICE—VINYL CHLORIDE EXPOSURE The manufacturing process of Solbin products results in residual Vinyl Chloride (VC) being contained in the product. During shipment, the exposure of this product to ambient temperatures causes the residual VC to volatilize and accumulate within the shipping container. Vinyl Chloride has both a very low flash point (-108 °F) and boiling point (7 °F). Ambient air testing has been conducted to determine the initial concentration of VC that an employee may be exposed to when opening the container doors prior to unloading the product.
