Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
EC/CAS
14807-96-6
Name of the chemical
Talc
Concentration
<5
General Information
Revision date
2015-05-15
Product name
Fast Setting Joint Compounds
1.2.1 Relevant identified uses
Setting type (or hardening) joint compounds used in joint finishing and repair of drywall. Use per manufacturer’s recommendations
1.2.2. Uses advised against
Use in well-ventilated area and avoid breathing dust Avoid skin contact
Icons in SDS
Company Information
company name
National Gypsum Company
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H315, H332, H350, H372
Hazard statements
Code
Statements
H315
Causes skin irritation
Section 2
SECTION 2: Hazards identification
GHS Classification United States (US)
Signal word
Danger
Hazard statements
H-350 May cause cancer. H-332, 372 Harmful if inhaled. Causes damage to organs (lungs) through prolonged or repeated exposure. H-315 Causes skin corrosion/irritation. (Continued)
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not breathe dust. Use personal protective equipment as required. (See Section 8) Use engineering controls and wet methods to minimize dust.
Response
If breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for breathing. If on skin, wash with plenty of soap and water. If in eyes, rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention if exposed or concerned.
Storage
Store material in a cool, dry, ventilated area, away from excessive heat or sunlight.
Disposal
Dispose of material in accordance with federal, state, and local regulations. Do not wash material down drains.
2.1 Classification of the substance or mixture
GHS Classification of the substance or mixture Carcinogenicity - Category 1A - (H-350) Specific target organ toxicity, repeated exposure – Category 1 (H-372) Acute toxicity, inhalation - Category 4 (H-332) Skin corrosion/irritation Category 2 (H315)
