Note: Ingredients listed on restricted chemical lists
EC/CAS
110-54-3
Name of the chemical
n-Hexan (790/2009)
Concentration
N/A
EC/CAS
64742-49-0
Name of the chemical
Naphtha (petroleum), hydrotreated light
Concentration
N/A
EC/CAS
68476-86-8
Name of the chemical
Petroleum gases, liquefied, sweetened
Concentration
90-100
General Information
Version
1.01
Revision date
2015-06-01
Product name
MG-50 MOLD GUARD
1.2.1 Relevant identified uses
and restrictions on use
1.2.2. Uses advised against
None
supplier name
Dry Rust Preventative
Manufacturer Name
Nanoplas Inc
Emergency telephone
1-800-424-9300
Icons in SDS
Company Information
company name
Nanoplas Inc
GHS Information
Signal word
DANGER
Hazard Codes
Hazard statements (CLP)
H222, H229, H280, H304, H315, H319, H335, H336, H361
Hazard statements
Code
Statements
H222
Extremely flammable aerosol
Section 2
SECTION 2: Hazards identification
OSHA Hazards Classification Note: This product is a consumer product and is labeled in accordance with the US Consumer Product Safety Commission
2.2 Label elements
Emergency Overview DANGER
Hazard statements
Causes skin irritation Causes serious eye irritation Suspected of damaging fertility or the unborn child May cause respiratory irritation. May cause drowsiness or dizziness May cause damage to organs (Central Nervous System, Central Vascular System,Eyes,Kidney,Liver,Lungs,Respiratory System, and Skin) through prolonged or repeated exposure. May be fatal if swallowed and enters airways Extremely flammable aerosol Contains gas under pressure; may explode if heated Appearance Clear Physical state Aerosol Odor Solvent
Prevention
Obtain special instructions before use Do not handle until all safety precautions have been read and understood Wear protective gloves/protective clothing/eye protection/face protection Wash face, hands and any exposed skin thoroughly after handling Do not breathe dust/fume/gas/mist/vapors/spray Use only outdoors or in a well-ventilated area Keep away from heat/sparks/open flames/hot surfaces. — No smoking Do not spray on an open flame or other ignition source Pressurized container: Do not pierce or burn, even after use
Response
If exposed or concerned: Get medical advice/attention Specific treatment (see first aid on this label) IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention IF ON SKIN: Wash with plenty of soap and water. Take off contaminated clothing and wash before reuse If skin irritation occurs: Get medical advice/attention IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER or doctor/physician if you feel unwell IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician Do NOT induce vomiting
Storage
Store locked up Store in a well-ventilated place. Keep container tightly closed Protect from sunlight. Store in a well-ventilated place
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
2.3 Other hazards
None
Further information
• Toxic to aquatic life with long lasting effects 0.48521% of the mixture consists of ingredient(s) of unknown toxicity
2.1 Classification of the substance or mixture
Note: This product is a consumer product and is labeled in accordance with the US Consumer Product Safety Commission regulations which take precedence over OSHA Hazard Communication labeling. The actual container label will not include the