Molytec Spraysafe Silicone

Hazard statements (CLP)

H222, H229, H315, H336

Code

Statements

H222

Extremely flammable aerosol

SECTION 2: Hazards identification

GHS Classification Classification of substance or mixture

Signal word

DANGER

Hazard statements

H222: Extremely flammable aerosol H229: Pressurized container may bust if heated. H315: Cause skin irritation. H336: May cause drowsiness or dizziness.

Prevention

P102: Keep out of reach of children. P210: Keep away from heat, sparks, open flames and hot surfaces. - No smoking. P211: Do not spray on an open flame or other ignition source. P251 Pressurised container Do not pierce or burn, even after use P261: Avoid breathing fumes, mists, vapours or spray. P264: was thoroughly after handling. P271: Use only outdoors or in a well ventilated area. P280: Wear protective gloves, protective clothing and eye or face protection.

Response

P312: Call a POISON CENTRE or doctor if you feel unwell. P321: Specific treatment is advised- see first aid instructions. P391: Collect spillage. P302+P352 If on skin was with plenty of water and soap. P362: Take off contaminated clothing and wash before reuse. P363: Wash contaminated clothing before reuse. P304+P340 IF INHALED Remove victim to fresh air and keep at rest in a position comfortable for breathing P332+P313: If skin irritation occurs get medical advice/attention.

Storage

P405: Store locked up. P403+P233: Store in a well-ventilated place, keep container tightly closed. P410+P412: Protect from sunlight. Do not expose to temperatures exceeding 50°C.

Disposal

P501: Dispose of small quantities and empty containers by wrapping with paper and putting in garbage. For larger quantities, if recycling or reclaiming is not possible, use a commercial waste disposal service. Composition and Information on Chemical Ingredients Ingredients CAS No. Conc, % TWA (mg/m³) STEL (mg/m³) Alkanes, C 3-4 68475-59-2 >80 Not set ** Not set Non hazardous silicone Secret <20 Not set ** Note that SWA regards propane as an asphyxiant and sets a TWA of 1900 mg/m3 for butane. This is a commercial product whose exact ratio of components may vary slightly. Minor quantities of other non hazardous ingredients are also possible. The SWA TWA exposure value is the average airborne concentration of a particular substance when calculated over a normal 8 hour working day for a 5 day working week. The STEL (Short Term Exposure Limit) is an exposure value that may be equalled (but should not be exceeded) for no longer than 15 minutes and should not be repeated more than 4 times per day. There should be at least 60 minutes between successive exposures at the STEL. The term "peak "is used when the TWA limit, because of the rapid action of the substance, should never be exceeded, even briefly.

2.1 Classification of the substance or mixture

Classified as hazardous according to Australian WHS regulations GHS Classification: Aerosol Flammable Category 1 Aerosol Pressurised Category 1 Skin Corrosion/Irritant 2 Specific target organ systemic toxicity (single exposure) Category 3 Aquatic toxicity Category 2