General Information
Version
0.02
Revision date
2025-01-22
Product name
MAHOGANY SMC
Chemical name
Reinforced Sheet
supplier name
MOLDING PRODUCTS LLC
Emergency telephone
800.424.9300, +1 703.741.5970
Icons in SDS
Company Information
company name
MOLDING PRODUCTS LLC
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H315, H319, H332, H350, H372
Hazard statements
Code
Statements
H315
Causes skin irritation
Section 2
SECTION 2: Hazards identification
Classification of the substance or mixture ACUTE TOXICITY (inhalation) - Category 4 SKIN IRRITATION - Category 2 EYE IRRITATION - Category 2A CARCINOGENICITY - Category 1 SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 1
Signal word
Danger
Hazard statements
Causes skin irritation. Causes serious eye irritation. Harmful if inhaled. May cause cancer. Causes damage to organs through prolonged or repeated exposure. (respiratory system)
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves. Wear protective clothing. Wear eye or face protection Recommended safety glasses with side-shields.. Use only outdoors or in a well-ventilated area. Do not breathe dust. Do not eat, drink or smoke when using this product. Wash thoroughly after handling.
Response
IF exposed or concerned Get medical advice or attention. IF INHALED Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER or doctor if you feel unwell. IF ON SKIN: Wash with plenty of water. If skin irritation occurs: Get medical advice or attention. Take off contaminated clothing and wash it before reuse. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice or attention.
Storage
Store locked up.
Disposal
Dispose of contents and container in accordance with all local, regional, national and international regulations.
Ingredient(s) with unknown acute toxicity
toxicity: 50.8%
Additional information
Hazard classification applies to compound without the sealed film. When compound is cured, grinding, cutting, or sanding can generate dust and create additional inhalation hazards.
2.1 Classification of the substance or mixture
ACUTE TOXICITY (inhalation) - Category 4 substance or mixture SKIN IRRITATION - Category 2 EYE IRRITATION - Category 2A CARCINOGENICITY - Category 1 SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 1
