General Information
Revision date
2016-02-01
Product name
MS-122ADL
1.2.1 Relevant identified uses
Release Agent or Dry Lubricant H1212A PTFE Release Agent/Dry Lubricant
Emergency telephone
(800) 424-9300
Icons in SDS
Company Information
company name
Miller-Stephenson Chemical
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H229, H280
Hazard statements
Code
Statements
H229
Pressurized container: may burst if heated
Section 2
SECTION 2: Hazards identification
Physical hazards
Gases under pressure – Liquefied Gas
Signal word
Warning
Hazard statements
Contains gas under pressure; may explode if heated.
Precautionary statements
Avoid breathing spray Wash skin thoroughly after handling. Use in a well-ventilated area. In case of EYE contact, immediately flush eyes with plenty of water. If eye irritation persists: Get medical attention. IF ON SKIN: Remove/Take off all contaminated clothing, immediately. Rinse skin with water. If INHALED: Remove victim to fresh air. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F Pressurized container. Do not pierce or burn, even after use. Hazardous prevention measures: Avoid release to the environment. Dispose of contents/container to an approved waste disposal plant. Other hazards which do not result in classification or are not covered by GHS Vapors are heavier than air and can cause suffocation by reducing oxygen available for breathing. May cause cardiac arrhythmia. The thermal decomposition vapors of fluorinated polymers may cause polymer fume fever with flu-like symptoms in humans, especially when smoking contaminated tobacco. Repeated episodes of polymer fume fever may result in persistent lung effects. 3. INGREDIENTS Material (s) CAS No. Approximate % Trans-1,3,3,3-Tetrafluoroprop-1-ene (HFO-1234ze) 29118-24-9 88 - 92 Isopropyl Alcohol 67-63-0 5 - 10 Poly-TFE, Omega-Hydro-Alpha-(Methylcyclohexyl)- 65530-85-0 1 - 2 Poly-Tetrafluoroethylene 9002-84-0 < 1
