General Information
Revision date
2021-05-01
Product name
MS-122AD
1.2.1 Relevant identified uses
Release Agent or Dry Lubricant MS-122ADM DPMS-Z0918A PTFE Release Agent/Dry Lubricant
Emergency telephone
(800) 424-9300
Icons in SDS
Company Information
company name
Miller-Stephenson Chemical
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H229, H280
Hazard statements
Code
Statements
H229
Pressurized container: may burst if heated
Section 2
SECTION 2: Hazards identification
Physical hazards
Gases under pressure – Liquefied Gas
Signal word
Warning
Hazard statements
Contains gas under pressure; may explode if heated. May displace oxygen and cause rapid suffocation.
Precautionary statements
Avoid breathing mist/vapor/spray. Wash skin thoroughly after handling. Use only outdoors or in a well-ventilated area. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. IF ON SKIN: Remove/Take off all contaminated clothing, immediately. Rinse skin with water. IF INHALED: Remove victim to fresh air and keep at rest in position comfortable for breathing. Protect from sunlight. Do not expose to temperature exceeding 50°C/122°F. Do not spray on an open flame or other ignition source. Pressurized container. Do not pierce or burn, even after use. Dispose of contents/container to an approved waste disposal plant. Other hazards which do not result in classification or are not covered by GHS Vapors are heavier than air and can cause suffocation by reducing oxygen available for breathing. Misuse or intentional inhalation abuse may cause death without warning symptoms, due to cardiac effects. The thermal decomposition vapors of fluorinated polymers may cause polymer fume fever with flu-like symptoms in humans, especially when smoking contaminated tobacco. 3. INGREDIENTS Material (s) CAS No. Approximate % 1,1,1,2-Tetrafluoroethane 811-97-2 90 - 95 Isopropyl Alcohol 67-63-0 5 - 10