Note: Ingredients listed on restricted chemical lists
EC/CAS
106-97-8
Name of the chemical
n-Butan, enthält 0,1% Butadien
Concentration
N/A
General Information
Revision date
2019-01-09
Product name
MARC 165 CUT ‘N’ TAP
1.2.1 Relevant identified uses
Cutting and tapping fluid PREPARED BY: MARC
supplier name
Mid-American Research Chemical Corp
Icons in SDS
Company Information
company name
Mid-American Research Chemical Corp
e-mail address of the competent person responsible for the Safety Data Sheet
marc@marc1.com
GHS Information
Signal word
Danger
Section 2
2.1 Classification of the substance or mixture
Physical hazards Flammable aerosols Category 1. Health hazards Serious eye damage/eye irritation Category 2A Specific target organ toxicity, single exposure Category 3 narcotic effects.
Signal word
Danger Hazard statement Extremely flammable aerosol. Causes serious eye irritation. May cause drowsiness or dizziness
Prevention
Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use. Avoid breathing gas. Wash thoroughly after handling. Use only outdoors or in a well-ventilated area. Wear eye protection/face protection. Response- If inhaled: Remove person to fresh air and keep comfortable for breathing. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Call a poison center/doctor if you feel unwell. If eye irritation persists: Get medical advice/attention. Storage- Store in a well-ventilated place. Keep container tightly closed. Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Disposal- Dispose of contents/container in accordance with local/regional/national/international regulations.
