Note: Ingredients listed on restricted chemical lists
EC/CAS
215-691-6/1344-28-1
Name of the chemical
aluminium oxide
Concentration
60-100%
EC/CAS
215-108-5/1302-78-9
Name of the chemical
bentonite
Concentration
1-5%
EC/CAS
244-492-7/21645-51-2
Name of the chemical
Aluminium hydroxide
Concentration
1-5%
EC/CAS
238-878-4/14808-60-7
Name of the chemical
Silica, crystalline
Concentration
0.1-0.5%
General Information
Revision date
2017-01-09
Product name
Microgrit WCA B, Microgrit WCA T
Product Synonyms
Aluminum Oxide with Suspension Treatment
1.2.1 Relevant identified uses
Lapping
1.2.2. Uses advised against
None identified
Emergency telephone
In United States, Canada, Puerto Rico, and the U.S. Virgin Islands: 1 (800) 255-3924
Icons in SDS
Company Information
company name
Micro Abrasives Corporation
e-mail address of the competent person responsible for the Safety Data Sheet
SDS@microgrit.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H350, H373
Hazard statements
Code
Statements
H350
May cause cancer
Section 2
SECTION 2: Hazards identification
2.1 Classification of the substance or mixture
EU Carcinogen Category 1A; Specific Target Organ Toxicity – Repeat Exposure Category 2 US
EU Classification
1999/45/EC) Not classified as dangerous
2.2 Label elements
Danger!
Contains
Kaolin and Crystalline Silica, quartz
Precautionary statements
H373 May cause damage to lungs through P201 Obtain special instructions before use. prolonged or repeated exposure by inhalation P202 Do not handle until all safety precautions have been read and H350 May cause cancer by inhalation. understood. P260 Do not breathe dust. P280 Wear protective gloves, protective clothing, eye protection or face protection. P308 + P313 IF exposed or concerned: Get medical attention. P501 Dispose of contents and container in accordance with local and national regulations.
Supplemental label elements
Prolonged exposure to elevated noise levels during operations may affect hearing. A greater hazard, in most cases, is the exposure to the dust/fumes from the material or paint/coatings being processed. Most of the dust generated during abrasive processing is from the base material or coatings and the potential hazard from this exposure must be evaluated. This dust may present a fire or dust explosion hazard and may present a serious health hazard.
2.3 Other hazards
None identified
