Note: Ingredients listed on restricted chemical lists
EC/CAS
7647-01-0
Name of the chemical
Hydrochloric acid
Concentration
<1
EC/CAS
7732-18-5
Name of the chemical
Water, distilled, conductivity or of similar purity H2O
Concentration
N/A
EC/CAS
231-791-2
Name of the chemical
Water, distilled, conductivity or of similar purity H2O
Concentration
N/A
General Information
Product name
MG 120 Flux
supplier name
N94 W14355 GARWIN MACE DRIVE
Manufacturer Name
MESSER - MG WELDING PRODUCTS
Icons in SDS
Company Information
company name
MESSER - MG WELDING PRODUCTS
GHS Information
Signal word
DANGER
Section 2
SECTION 2: Hazards identification
EMERGENCY OVERVIEW: Target organ statement DANGER Causes severe burns to skin, eyes, and respiratory system. May be fatal if swallowed Does not pose a fire hazard as shipped. Non-Flammable: However, heat and flames used during brazing and soldering can ignite combustibles. Refer to American National Standard Z49.1 for fire prevention during welding and soldering.
Potential health effects
Swallowing May be fatal. Can cause damage to digestive system. Corrosive to mucous membranes Skin absorption None currently known. Inhalation Irritation to respiratory system. Coughing and sneezing. Existing lung disorders will be aggravated. Skin Contact Dermatitis, possible chemical burns, corrosive to skin. Existing disorders will be aggravated. Eye Contact Irritation to the eyes, tearing, burn of the eye surfaces, corrosive to the eyes, may cause blindness.
Principle Routes of Exposure
Primary route of entry is the respiratory system. Other possible routes are eyes, ingestion, and/or skin contact.
Hazard statements
Corrosive, Harmful, Dangerous for the environment H302 Harmful if swallowed. H315 Causes skin irritation. H319 Causes serious eye irritation. H360FD May damage fertility. May damage the unborn child.
R-phrase(s)
Contact with acids liberates very toxic gas. Harmful if swallowed. Causes burns. Very toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment. Although this product does not require a hazard warning label in all countries, we recommend the following GHS pictograms: Danger Corrosive Environment Respiratory Toxic Contains zinc chloride and hydrochloric acid
Precautionary statements
P285 In case of inadequate ventilation wear respiratory protection. P314 Get medical advice/attention if you feel unwell. P280 Wear protective gloves/protective clothing/eye protection/face protection. P202 Do not handle until all safety precautions have been read and understood. P260 Do not breathe dust/fume/gas/mist/vapors/spray. P501 Dispose of contents/container to waste treatment facility in accordance with local and national regulations. WARNING: avoid breathing welding fumes and gases; they may dangerous to your health. Always use adequate ventilation and use appropriate personal protection equipment. CARCINOGENICITY WELDING FUMES (not otherwise specified) are considered to be carcinogenic defined with no further categorization by NIOSH and IARC. See additional information in Section 3 for ingredients. Before using this product, contact your doctor to determine if exposure to product or use of this product will aggravate your medical conditions. Spatter and flames from brazing and soldering may cause burns.