Note: Ingredients listed on restricted chemical lists
EC/CAS
7631-86-9
Name of the chemical
Silver adsorbed on silicon dioxide
Concentration
N/A
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
EC/CAS
1305-78-8
Name of the chemical
Calcium oxide
Concentration
N/A
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
General Information
Revision date
2021-12-17
Product name
EZ Crete
1.2.1 Relevant identified uses
Floor underlayment
supplier name
Maxxon Corporation
Icons in SDS
Company Information
company name
Maxxon Corporation
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
OSHA defined hazards Emergency overview: Harmful if swallowed. Causes serious eye damage. Causes skin irritation. May cause an allergic skin reaction. Suspected of causing cancer. A natural chemical reaction during hardening (rehydration) develops sufficient heat that may cause severe burns in the event of contact with skin. These burns may possibly result in permanent injury. Do not allow product to harden around any body part or allow continuous, prolonged contact with skin. Crushing, mixing, sanding, or otherwise working with this product may generate large amounts of dust. Dust can be irritating to the eyes, skin, and respiratory system.
Signal word
Danger
Physical hazards
Not classified
Health hazards
Acute toxicity, oral: Category 4 Skin corrosion/irritation: Category 2 Serious eye damage/eye irritation: Category 1 Sensitization, skin: Category 1 Carcinogenicity: Category 2
Environmental hazards
Hazardous to the aquatic environment, long-term hazard: Category 3 OSHA defined Hazards: Not classified Hazards statment: Harmful if swallowed. Causes serious eye damage. Causes skin irritation. May cause an allergic skin reaction. Suspected of causing cancer. Harmful to aquatic life with long lasting effects 1 Continued
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Avoid breathing dust. Wash thoroughly after handling. Do not eat, drink, or smoke when using this product. Contaminated work clothing must not be allowed out of the workplace. Avoid release to the environment. Wear protective gloves. Wear eye/face protection. After mixing with water, do not allow prolonged contact with skin until the product has completely hardened and cooled.
Response
If swallowed: Rinse mouth. Call a poison center/doctor if you feel unwell. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a poison center/ doctor. If on skin: Wash with plenty of water. If skin irritation or rash occurs: Get medical advice/attention. Take off contaminated clothing and wash before reuse. If exposed or concerned: Get medical advice/attention. For specific treatment see Section 4 on the SDS.
Storage
Store locked up. Keep container tightly closed. Store away from strong acids, phosphorus, diazomethane, and aluminum (at high temperatures). Protect from moisture.
Disposal
Dispose of contents/container in accordance with applicable regulations. Hazard(s) not otherwise
Classified (HNOC)
Heat develops as product hardens. May cause serious burns during hardening (rehydration) resulting in possible permanent injury.
Additional information
None. 2