Note: Ingredients listed on restricted chemical lists
EC/CAS
7440-41-7
Name of the chemical
Beryllium
Concentration
20-62
General Information
Revision date
2024-03-29
Product name
AlBeMet Powder
Product Synonyms
Aluminum Beryllium Matrix, AlBeMet® 120, AlBeMet® 130, AlBeMet® 140, AlBeMet® 150, AlBeMet® 160, AlBeMet® 162, AlBeMet® 562
Manufacturer Name
Materion Brush Inc
Emergency telephone
1.800.862.4118
Icons in SDS
Company Information
company name
Materion Brush Inc
e-mail address of the competent person responsible for the Safety Data Sheet
ehs@materion.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H228, H350i
Hazard statements
Code
Statements
H228
Flammable solid
Section 2
SECTION 2: Hazards identification
Physical hazards
Flammable solids Category 2
Health hazards
Carcinogenicity Category 1 Specific target organ toxicity, repeated Category 1 (Respiratory system) exposure
Environmental hazards
Not classified.
Signal word
Danger
Hazard statements
Flammable solid. May cause cancer by inhalation. Causes damage to organs (respiratory system) through prolonged or repeated exposure by inhalation.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Minimize dust generation and accumulation. Do not breathe dust/fume. Wash thoroughly after handling. Do not eat, drink or smoke when using this product. Contaminated work clothing must not be allowed out of the workplace. Wear protective gloves/protective clothing/eye protection/face protection. Wear respiratory protection.
Response
If on skin Wash with plenty of water. If inhaled Remove person to fresh air and keep comfortable for breathing. If exposed or concerned: Call a poison center/doctor. If skin irritation or rash occurs: Get medical advice/attention. If experiencing respiratory symptoms: Call a poison center/doctor. Wash contaminated clothing before reuse.
Storage
Store locked up.
Disposal
Dispose of contents/container in accordance with local/regional/national/international regulations. Hazard(s) not otherwise None known.
Additional information
Exposure to the elements listed in Section 3 by inhalation, ingestion, and skin contact can occur when melting, casting, dross handling, pickling, chemical cleaning, heat treating, abrasive cutting, welding, grinding, sanding, polishing, milling, crushing, or otherwise heating or abrading the surface of this material in a manner which generates particulate. For further information, please contact the Product Stewardship Department at +1.800.862.4118.
