Note: Ingredients listed on restricted chemical lists
EC/CAS
238-878-4/14808-60-7
Name of the chemical
Silica, crystalline
Concentration
≥25-<50
EC/CAS
247-761-7/26530-20-1
Name of the chemical
2-Octyl-2H-isothiazol-3-one
Concentration
≥0.0015- <0.005% 00-5
EC/CAS
215-279-6
Name of the chemical
Calcium carbonate
Concentration
≥2.5-<5
General Information
Revision date
2023-03-14
Product name
PLASTIMUL
1.2.1 Relevant identified uses
Coating
1.2.2. Uses advised against
Data not available
supplier name
MAPEI AUSTRALIA Pty Ltd
Icons in SDS
Company Information
company name
MAPEI AUSTRALIA Pty Ltd
e-mail address of the competent person responsible for the Safety Data Sheet
sales@mapei.com.au
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H317
Hazard statements
Code
Statements
H317
May cause an allergic skin reaction
Section 2
SECTION 2: Hazards identification
2.1 Classification of the substance or mixture
Skin Sensitisation, Category 1A May cause an allergic skin reaction. Adverse physicochemical, human health and environmental effects: No other hazards
Adverse physicochemical, human health and environmental effects
No other hazards
2.2 Label elements
Pictograms and Signal Words Warning
Hazard statements
H317 May cause an allergic skin reaction.
Precautionary statements
P261 Avoid breathing mist/vapours/spray. P272 Contaminated work clothing must not be allowed out of the workplace. P280 Wear protective gloves/clothing and eye/face protection. P302+P352 IF ON SKIN: Wash with plenty of water. P321 Specific treatment (see supplementary instructions on this label) P333+P313 If skin irritation or rash occurs: Get medical advice/attention. P362+P364 Take off contaminated clothing and wash it before reuse. P501 Dispose of contents/container in accordance with applicable regulations.
2.3 Other hazards
No other This product contains crystalline silica (quartz sand). IARC has classified crystalline silica as a Group 1 carcinogen. Both IARC and NTP consider silica as a known human carcinogen. Evidence is based on the chronic and long-term exposure workers have had to respirable sized crystalline silica dust particles. Because this product is in liquid or paste form, it does not pose a dust hazard; therefore, this classification is not relevant. (Note: sanding of the hardened product may create a silica dust hazard)
