Vanilla CO2 EOD Madar Corp

SECTION 2: Hazards identification

Signal word

None

Hazard statements

None

Additional information

EUH208, Contains Anisyl alcohol. May produce an allergic reaction. EUH210, Safety data sheet available on request.

Precautionary statements

None

Hazard pictograms

None

Other hazards

None

2.1 Classification of the substance or mixture

Classification under Regulation (EC) No 1272/2008 Class and category of This material does not meet the criteria for classification under Regulation (EC) No 1272/2008. danger: 2.2 Label elements Classification under Regulation (EC) No 1272/2008 Signal word: None Hazard statements: None Supplemental EUH208, Contains Anisyl alcohol. May produce an allergic reaction. Information: EUH210, Safety data sheet available on request. Precautionary None statements: Pictograms: None 1 2.3 Other hazards Other hazards: None Section 3. Composition / information on ingredients 3.2 Mixtures Contains: Not Applicable Substances with Community workplace exposure limits: Not Applicable Substances that are persistent, bioaccumulative and toxic or very persistent and very bioaccumulative, greater than 0.1%: Not Applicable Section 4. First-aid measures 4.1 Description of first aid measures Inhalation: Remove from exposure site to fresh air, keep at rest, and obtain medical attention. Eye exposure: Flush immediately with water for at least 15 minutes. Contact physician if symptoms persist. Skin exposure: Remove contaminated clothes. Wash thoroughly with soap and water. Contact physician if irritation persists. Ingestion: Rinse mouth with water and obtain medical attention. 4.2 Most important symptoms and effects, both acute and delayed None expected, see Section 4.1 for further information. 4.3 Indication of any immediate medical attention and special treatment needed None expected, see Section 4.1 for further information. SECTION 5: Firefighting measures 5.1 Extinguishing media Suitable media: Carbon dioxide, Dry chemical, Foam. 5.2 Special hazards arising from the substance or mixture In case of fire, may be liberated: Carbon monoxide, Unidentified organic compounds. 1 5.3 Advice for fire fighters: In case of insufficient ventilation, wear suitable respiratory equipment. Section 6. Accidental release measures 6.1 Personal precautions, protective equipment and emergency procedures: Avoid inhalation. Avoid contact with skin and eyes. See protective measures under Section 7 and 8. 6.2 Environmental precautions: Keep away from drains, surface and ground water, and soil. 6.3 Methods and material for containment and cleaning up: Remove ignition sources. Provide adequate ventilation. Avoid excessive inhalation of vapours. Contain spillage immediately by use of sand or inert powder. Dispose of according to local regulations. 6.4 Reference to other sections: Also refer to sections 8 and 13. Section 7. Handling and storage 7.1 Precautions for safe handling: Keep away from heat, sparks, open flames and hot surfaces. - No smoking. Use personal protective equipment as required. Use in accordance with good manufacturing and industrial hygiene practices. Use in areas with adequate ventilation Do not eat, drink or smoke when using this product. 7.2 Conditions for safe storage, including any incompatibilities: Store in a well-ventilated place. Keep container tightly closed. Keep cool. Ground/bond container and receiving equipment. Use explosion-proof electrical, ventilating and lighting equipment. Use only non-sparking tools. Take precautionary measures against static discharge. 7.3 Specific end use(s): Fragrances: Use in accordance with good manufacturing and industrial hygiene practices. Section 8. Exposure controls/personal protection 8.1 Control parameters Workplace exposure limits: Not Applicable 8.2 Exposure Controls Eye / Skin Protection Wear protective gloves/eye protection/face protection Respiratory Protection 1 Under normal conditions of use and where adequate ventilation is available to prevent build up of excessive vapour, this material should not require special engineering controls. However, in conditions of high or prolonged use, or high temperature or other conditions which increase exposure, the following engineering controls can be used to minimise exposure to personnel: a) Increase ventilation of the area with local exhaust ventilation. b) Personnel can use an approved, appropriately fitted respirator with organic vapour cartridge or canisters and particulate filters. c) Use closed systems for transferring and processing this material. Also refer to Sections 2 and 7. Section 9. Physical and chemical properties 9.1 Information on basic physical and chemical properties Appearance: Clear Yellow Odour: Sweet Odour threshold: Not determined pH: Not determined Melting point / freezing point: Not determined Initial boiling point / range: Not determined Flash point: 140 Evaporation rate: Not determined Flammability (solid, gas): Not determined Upper/lower flammability or explosive limits: Product does not present an explosion hazard Vapour pressure: Not determined Vapour density: Not determined Relative density: 0.858 - 0.868 Solubility(ies): Not determined Partition coefficient: n-octanol/water: Not determined Auto-ignition temperature: Not determined Decomposition temperature: Not determined Viscosity: Not determined Explosive properties: Not expected Oxidising properties: Not expected Refractive Index: 1.46061 - 1.47037 Optical Rotation: -0.87 9.2 Other information: None available Section 10. Stability and reactivity 10.1 Reactivity: Presents no significant reactivity hazard, by itself or in contact with water. 10.2 Chemical stability: Good stability under normal storage conditions. 1 10.3 Possibility of hazardous reactions: Not expected under normal conditions of use. 10.4 Conditions to avoid: Avoid extreme heat. 10.5 Incompatible materials: Avoid contact with strong acids, alkalis or oxidising agents. 10.6 Hazardous decomposition products: Not expected. Section 11. Toxicological information 11.1 Information on toxicological effects This mixture has not been tested as a whole for health effects. The health effects have been calculated using the methods outlined in Regulation (EC) No 1272/2008 (CLP). This material does not meet the criteria for classification for health hazards under Regulation (EC) No 1272/2008. Acute Toxicity: Based on available data the classification criteria are not met. Acute Toxicity Oral Not Applicable Acute Toxicity Dermal Not Applicable Acute Toxicity Inhalation Not Available Skin corrosion/irritation: Based on available data the classification criteria are not met. Serious eye damage/irritation: Based on available data the classification criteria are not met. Respiratory or skin sensitisation: Based on available data the classification criteria are not met. Germ cell mutagenicity: Based on available data the classification criteria are not met. Carcinogenicity: Based on available data the classification criteria are not met. Reproductive toxicity: Based on available data the classification criteria are not met. STOT-single exposure: Based on available data the classification criteria are not met. STOT-repeated exposure: Based on available data the classification criteria are not met. Aspiration hazard: Based on available data the classification criteria are not met. Information about hazardous ingredients in the mixture Not Applicable Refer to Sections 2 and 3 for additional information. Section 12. Ecological information 12.1 Toxicity: Not available 12.2 Persistence and degradability: Not available 12.3 Bioaccumulative potential: Not available 12.4 Mobility in soil