General Information
Version
1.0
Revision date
2018-09-03
Product name
ABS-R 3D Ink
Product Synonyms
Not available
Chemical name
Not available
1.2.2. Uses advised against
Do not use in 3D printers where temperatures exceed 270°C. Do not use in 3D printers without temperature runaway controls
supplier name
M3D, LLC
Emergency telephone
1 (800) 222-1222
Icons in SDS
Company Information
company name
M3D, LLC
e-mail address of the competent person responsible for the Safety Data Sheet
info@printm3d.com
GHS Information
Signal word
Not applicable
Section 2
SECTION 2: Hazards identification
Identification
Physical hazards
Not applicable
Health hazards
Not applicable
Environmental hazards
Not applicable
Signal word
Not applicable
Hazard statements
Not applicable
Hazard pictograms
Not applicable
Precautionary statements
Safety Measures and Prevention: Do not breathe dust/fume/gas/mist.
Response
Get medical attention/advice if you feel unwell
Storage
Keep away from fire. Store indoors at ambient temperature
Disposal
Do not dump into sewers, on the ground or into any body of water. Burn in an adequate incinerator or bury in landfill. Dispose of contents and container in accordance with local, state, national, and international regulations.
2.3 Other hazards
PBT and vPvB Substances: Material does not contain PBT and vPvB substances.
NFPA Ratings
Health: 0 Fire: 1 Reactivity: 0 Hazard Scale: 0 = Minimal, 1 = Slight, 2 = Moderate, 3 = Serious, 4 = Severe
