Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
30 - 60
EC/CAS
143925-92-2
Name of the chemical
CGA 042
Concentration
0.1 - 1
General Information
Version
1.1
Revision date
2026-08-14
Product name
POLYBATCH WHITE P80882
supplier name
LyondellBasell Advanced Polymers, Inc
Emergency telephone
1-800-424-9300, +1 703-741-5970
Icons in SDS
Company Information
company name
LyondellBasell Advanced Polymers, Inc
e-mail address of the competent person responsible for the Safety Data Sheet
product.safety@lyondellbasell.com
GHS Information
Signal word
Warning
Section 2
SECTION 2: Hazards identification
2.1 Classification of the substance or mixture
Skin sensitization, Category 1 May cause an allergic skin reaction. Combustible dust May form combustible dust concentrations in air [if small particles are generated during further processing, handling or by
Signal word
Warning
Hazard statements
May cause an allergic skin reaction If small particles are generated during further processing, handling or by other means, may form combustible dust concentrations in air.
Precautionary statements
Avoid breathing dust, fume, gas, mist, spray, vapours. Contaminated work clothing must not be allowed out of the workplace. Wear protective clothing, protective gloves, eye protection. If on skin: Wash with plenty of water. If skin irritation or rash occurs: Get medical advice or attention. Take off contaminated clothing and wash it before reuse. Dispose of an approved waste disposal plant to hazardous or special waste collection point, in accordance with local, regional, national and/or international regulations. 2.3. Hazards associated with known or reasonably anticipated uses No additional information available
Other hazards which do not result in classification
The components of this product are encapsulated and present no potential for exposure as shipped. This product is not hazardous in the form in which it is shipped by the manufacturer. The product is not expected to create any unusual hazards when handled and processed according to good manufacturing practices and the guidelines in this SDS.