Note: Ingredients listed on restricted chemical lists
EC/CAS
236-675-5/13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
3-<4%
EC/CAS
202-849-4/100-41-4
Name of the chemical
Ethylbenzene
Concentration
1-<2%
EC/CAS
202-966-0/101-68-8
Name of the chemical
4,4’-Methylenediphenyl diisocyanate
Concentration
0,7-<1%
General Information
Version
2 (Replaced 1
Revision date
2024-11-28
Product name
CH04020021/4 - CHEMIPOL SEAL&BOND PU 40-600ml
1.2.1 Relevant identified uses
Sealant . For professional users/industrial user only
1.2.2. Uses advised against
All uses not specified in this section or in section 7.3
Emergency telephone
800 250 250
Icons in SDS
Company Information
company name
Lusavouga
e-mail address of the competent person responsible for the Safety Data Sheet
lusavouga@lusavouga.pt
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H334
Hazard statements
Code
Statements
H334
May cause allergy or asthma symptoms or breathing difficulties if inhaled
Section 2
SECTION 2: Hazards identification
Hazard statements
Resp. Sens. 1: H334 - May cause allergy or asthma symptoms or breathing difficulties if inhaled.
Precautionary statements
P261: Avoid breathing dust/fume/gas/mist/vapours/spray. P285: In case of inadequate ventilation wear respiratory protection. P304+P340 IF INHALED Remove person to fresh air and keep comfortable for breathing P342+P311 If experiencing respiratory symptoms Call a POISON CENTER or doctor/physician P501: Dispose of contents/ container in accordance with local/regional/national/international regulation.
Supplemental label elements
EUH204: Contains isocyanates. May produce an allergic reaction. EUH211: Warning! Hazardous respirable droplets may be formed when sprayed. Do not breathe spray or mist.
Additional information
As from 24 August 2023 adequate training is required before industrial or professional use. Persons already sensitised to diisocyanates may develop allergic reactions when using this product. Persons suffering from asthma, eczema or skin problems should avoid contact, including dermal contact, with this product. This product should not be used under conditions of poor ventilation unless a protective mask with an appropriate gas filter (i.e. type A1 according to standard EN 14387) is used.
2.3 Other hazards
Changes with regards to the previous version ** (continued) Product fails to meet PBT/vPvB criteria Endocrine-disrupting properties: The product fails to meet the criteria. ** Changes with regards to the previous version
