Note: Ingredients listed on restricted chemical lists
EC/CAS
119-47-1
Name of the chemical
6,6'-di-tert-butyl-2,2'-methylenedi-p-cresol
Concentration
15-20% 0.1-0.9%
EC/CAS
1843-03-4
Name of the chemical
Phenol, 4,4',4''-(1-methyl-1-propanyl-3-ylidene)tris[2-(1,1-dimethylethyl)-5-methyl
Concentration
0.1-0.9%
General Information
Revision date
2022-04-03
Product name
THERMOSET UR-312 RESIN
1.2.1 Relevant identified uses
Encapsulant, Part A LORD Corporation 111 LORD Drive Cary, NC 27511-7923 USA
Emergency telephone
800 424-9300, 703 527-3887
Icons in SDS
Company Information
company name
LORD Corporation
GHS Information
Signal word
DANGER
Section 2
SECTION 2: Hazards identification
2.1 Classification of the substance or mixture
Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2A Skin sensitization Category 1 Reproductive toxicity Category 1B
Signal word
DANGER
Hazard statements
Causes skin irritation. Causes serious eye irritation. May cause an allergic skin reaction. May damage fertility or the unborn child.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves/eye protection/face protection. Use personal protective equipment as required. Avoid breathing dust/fume/gas/mist/vapors/spray. Wash thoroughly after handling. Contaminated work clothing should not be allowed out of the workplace.
Response
IF exposed or concerned: Get medical advice/attention. Specific treatment (see supplemental first aid instructions on this label). IF ON SKIN: Wash with plenty of soap and water. If skin irritation or rash occurs: Get medical advice/attention. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. 300000004557 Take off contaminated clothing and wash before reuse.
Storage
Store locked up.
Disposal
Dispose of contents/container in accordance with waste/disposal laws and regulations of your country or particular locality.
2.3 Other hazards
This product contains component(s) which have the following warnings; however based on the GHS classification criteria of your country or locale, the product mixture may be outside the respective category(s). Acute: Processing releases vapors which may cause eye, skin and respiratory tract irritation. May be harmful if swallowed. Ingestion is not an expected route of entry in industrial or commercial uses. Chronic: This product contains methylpolysiloxanes which can generate formaldehyde at approximately 300 degrees F (150 C) and above, in atmospheres which contain oxygen. Formaldehyde is a skin and respiratory sensitizer, eye and throat irritant, acute toxicant, and known cancer hazard. Workplace exposure to formaldehyde is regulated by
