Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
15-20% 0.1-0.9%
EC/CAS
110-85-0
Name of the chemical
Piperazin
Concentration
0.1-0.9%
General Information
Revision date
2023-10-03
Product name
FUSOR 132, 133 PLASTIC REPAIR ADH PT B
Product name
FUSOR 132, 133 PLASTIC REPAIR ADH PT B
Identification on the label/Trade name
FUSOR 132 133 PLASTIC REPAIR ADH PT B
1.2.1 Relevant identified uses
URETHANE ADHESIVE, PART 2 OF 2 LORD Corporation 111 LORD Drive Cary, NC 27511-7923 USA
Emergency telephone
800 424-9300, 703 527-3887
Icons in SDS
Company Information
company name
LORD Corporation
GHS Information
Signal word
DANGER
Section 2
SECTION 2: Hazards identification
2.1 Classification of the substance or mixture
Serious eye damage/eye irritation Category 2A Skin sensitization Category 1B Respiratory sensitization Category 1 Reproductive toxicity Category 2
Signal word
DANGER
Hazard statements
Causes serious eye irritation. May cause an allergic skin reaction. May cause allergy or asthma symptoms or breathing difficulties if inhaled. Suspected of damaging fertility or the unborn child.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Page 1 of 6 300001006408 Wear protective gloves, eye protection, face protection. Use personal protective equipment as required. In case of inadequate ventilation wear respiratory protection. Avoid breathing dust/fume/gas/mist/vapors/spray. Wash thoroughly after handling. Contaminated work clothing should not be allowed out of the workplace.
Response
IF exposed or concerned: Get medical advice, attention. Specific treatment (see supplemental first aid instructions on this label). IF INHALED: If breathing is difficult, remove to fresh air and keep at rest in a position comfortable for breathing. If experiencing respiratory symptoms: Call a POISON CENTER or doctor, physician. IF ON SKIN: Wash with plenty of soap and water. If skin irritation or rash occurs: Get medical advice, attention. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice, attention. Wash contaminated clothing before reuse.
Storage
Store locked up.
Disposal
Dispose of contents/container in accordance with waste/disposal laws and regulations of your country or particular locality.
2.3 Other hazards
This product contains component(s) which have the following warnings; however based on the GHS classification criteria of your country or locale, the product mixture may be outside the respective category(s). Acute: May cause mild skin irritation. May be harmful if swallowed. Ingestion is not an expected route of entry in industrial or commercial uses. Chronic: Prolonged exposure to the silica-containing sanding dust of this product could cause long-term lung damage. Crystalline silica is classified by IARC and NTP as a known human carcinogen as a respirable dust. The silica in Parker Lord products is not in a form that can be inhaled and presents no risk to the end user. No exposure is expected during normal use of this product. Sanding or abrading the cured materials is not recommended. Wear appropriate respiratory protection if exposure to dusts is possible.