Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
General Information
Revision date
2021-04-20
Product name
CIRCALOK 6744 B
CAS No.
14808-60-7
1.2.1 Relevant identified uses
Silicone Catalyst
Icons in SDS
Company Information
company name
LORD Corporation
GHS Information
Signal word
DANGER
Section 2
2.1 Classification of the substance or mixture
Specific target organ systemic toxicity (repeated exposure) Category 1 Respiratory system, Immune system, Kidney. Exposure is not expected during application of this product; possible exposure exists if the dried/cured product is sanded.
Signal word
DANGER
Hazard statements
Causes damage to organs through prolonged or repeated exposure.(Respiratory system, Immune system, Kidney)
Prevention
Do not breathe dust/fume/gas/mist/vapors/spray. Wash thoroughly after handling. Do not eat, drink or smoke when using this product.
Response
Get medical advice/attention if you feel unwell.
Storage
Refer to Section 7 of this SDS.
Disposal
Dispose of contents/container in accordance with waste/disposal laws and regulations of your country or particular locality.
2.3 Other hazards
This product contains component(s) which have the following warnings; however based on the GHS classification criteria of your country or locale, the product mixture may be outside the respective category(s). Acute: May cause skin and eye irritation. Chronic: Prolonged or repeated contact may result in dermatitis. This product contains methylpolysiloxanes which can generate formaldehyde at approximately 300 degrees F (150 C) and above, in atmospheres which contain oxygen. Formaldehyde is a skin and respiratory sensitizer, eye and throat irritant, acute toxicant, and known cancer hazard. Workplace exposure to formaldehyde is regulated by OSHA Standard 29 CFR 1910.1048. Prolonged exposure to the 300000003781 silica-containing sanding dust of this product could cause long-term lung damage. Crystalline silica is classified by IARC and NTP as a known human carcinogen as a respirable dust. The silica in Parker LORD products is not in a form that can be inhaled and presents no risk to the end user. No exposure is expected during normal use of this product. Sanding or abrading the cured materials is not recommended. Wear appropriate respiratory protection if exposure to dusts is possible.
