Note: Ingredients listed on restricted chemical lists
EC/CAS
231-157-5/7440-47-3
Name of the chemical
Chromium; chromic acid and its salts
Concentration
23-25
EC/CAS
231-111-4/7440-02-0
Name of the chemical
Nickel
Concentration
12-14
EC/CAS
231-105-1/7439-96-5
Name of the chemical
Manganese
Concentration
-2,5
EC/CAS
231-159-6/7440-50-8
Name of the chemical
Copper
Concentration
<=0,3
General Information
Revision date
2019-07-22
Product name
INERTROD 309L
1.2.1 Relevant identified uses
Gas shielding electric arc welding solid wire in rods
1.2.2. Uses advised against
No particular exclusions are known
Emergency telephone
INRS +33 (0)1.45.42.59.59
Icons in SDS
Company Information
company name
Lincoln Electric Europe B.V
e-mail address of the competent person responsible for the Safety Data Sheet
sds@lincolnelectriceurope.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H317, H351, H372
Hazard statements
Code
Statements
H317
May cause an allergic skin reaction
Section 2
CLP CLASSIFICATION
Mixtures/Substances SDS EU 2015 According to Regulation (EU) 2015/830 (REACH Annex II) Skin sensitisation, Category 1 H317 Carcinogenicity, Category 2 H351 Specific target organ toxicity — Repeated exposure, Category 1 H372
Hazard statements
see section 16
Adverse physicochemical, human health and environmental effects
No additional information available
2.2 Label elements
However the form in which product is placed on the market does not present a danger, such preparations do not require a label. Note 7 : Alloys containing nickel are classified for skin sensitisation when the release rate of 0,5 μg Ni/cm2/week, as measured by the European Standard reference test method EN 1811, is exceeded. No labelling applicable
Other hazards which do not result in classification
Spatter and melting metal can cause burn injuries. UV, IR radiations. Arc ray can severely damage eyes or skin. Formation of dangerous fumes during use. Inhalation of welding fumes may cause respiratory irritation. Cough. Hazardous decomposition products may be released during prolonged heating like smokes, carbon monoxide and dioxide. Excessive or prolonged inhalation of fumes may cause metal fever. Electric shocks can kill. Persons with a pacemaker should not go near welding or cutting operations until they have consulted their doctor and obtained information from the manufacturer of the device.
