Lincoln 860

Hazard statements (CLP)

H303, H314, H350, H372

Code

Statements

H303

May be harmful if swallowed

SECTION 2: Hazards identification

Classified according to the criteria of the Globally Harmonized System of Classification and Labeling of Chemicals (GHS). The product contains less than 0.1% of respirable crystalline silica. Emergency Overview Form Granular Physical state Solid

Hazard statements

Welding arc and sparks can ignite combustible and flammable products. Arc rays can injure eyes and burn skin. Electric shock can kill. Hazard Classification May be harmful if swallowed. Causes severe skin burns and eye damage. May cause cancer. Causes damage to organs Lungs through prolonged or repeated exposure.

Health hazards

Acute toxicity (Oral) Category 5 Skin Corrosion/Irritation Category 1A Serious Eye Damage/Eye Irritation Category 1 Carcinogenicity Category 1A Specific Target Organ Toxicity - Category 1 Repeated Exposure

Signal word

Danger

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not breathe dust/fume/gas/mist/vapors/spray. Wash face, hands and any exposed skin thoroughly after handling. Do not eat, drink or smoke when using this product. Wear protective gloves/ protective clothing/ eye protection/ face protection.

Response

IF SWALLOWED: Rinse mouth. Do NOT induce vomiting. Call a POISON CENTER or doctor/ physician if you feel unwell. IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water [or shower]. Wash contaminated clothing before reuse. Specific treatment (see supplemental first aid instructions on this label). IF INHALED: Remove person to fresh air and keep comfortable for breathing. Immediately call a POISON CENTER or doctor/ physician. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. IF exposed or concerned: Get medical advice/attention.

Storage

Store locked up.

Disposal

Dispose of contents/ container to an approved facility in accordance with local, regional, national and international regulations.

Other hazards which do not result in classification

Electrical Shock can kill. If welding must be performed in damp locations or with wet clothing, on metal structures or when in cramped positions such as sitting, kneeling or lying, or if there is a high risk of unavoidable or accidental contact with work piece, use the following equipment: Semiautomatic DC Welder, DC Manual (Stick) Welder, or AC Welder with Reduced Voltage Control. Arc rays can injure eyes and burn skin. Welding arc and sparks can ignite combustibles and flammable materials. Overexposure to welding fumes and gases can be hazardous. Read and understand the manufacturer’s instructions, Safety Data Sheets and the precautionary labels before using this product. Refer to Section 8. Substance(s) formed under the The welding fume produced from this welding electrode may contain the conditions of use following constituent(s) and/or their complex metallic oxides as well as solid particles or other constituents from the consumables, base metal, or base metal coating not listed below. Chemical Identity Carbon dioxide Carbon monoxide Nitrogen dioxide Ozone CAS-No. 124-38-9 630-08-0 10102-44-0 10028-15-6

2.1 Classification of the substance or mixture

Health Hazards Acute toxicity (Oral) Category 5 Skin Corrosion/Irritation Category 1A Serious Eye Damage/Eye Irritation Category 1 Carcinogenicity Category 1A Specific Target Organ Toxicity - Category 1 Repeated Exposure