Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
EC/CAS
14464-46-1
Name of the chemical
Cristobalit (s. u. TRGS 906)
Concentration
N/A
EC/CAS
238-878-4
Name of the chemical
Quarz-A-Staub (s. u. TRGS 906)
Concentration
N/A
EC/CAS
238-455-4
Name of the chemical
Cristobalit (s. u. TRGS 906)
Concentration
N/A
General Information
Revision date
2020-11-02
Product name
KROMOPAN SIL PUTTY SOFT
1.2.1 Relevant identified uses
Addition curing silicone for dental impression. Professional use only
1.2.2. Uses advised against
Different uses other than that mentioned above
Icons in SDS
Company Information
company name
LASCOD SPA
e-mail address of the competent person responsible for the Safety Data Sheet
ricerca@lascod.it
GHS Information
Signal word
--
Section 2
2.1 Classification of the substance or mixture
The product is not classified as hazardous pursuant to the provisions set forth in EC Regulation 1272/2008 (CLP) and subsequents amendments and adjustments. Mixture classification has been determined by the physical state in which it is commercialized and in which it can be reasonably consider will be used. Hazard classification and indication:
Precautionary statements
The product does not request hazard labeling in accordance with (CE) 1272/2008 (CLP) and subsequents amendments and adjustments. .
2.3 Other hazards
The hazardous characteristics of the raw materials listed below are in any case lost the moment those substances are mixed with other fluid components, generating the final product, which, in its pasty form, does not generate dust given it is contained within a matrix constituted by silicone oils. Similarly, for the use of the hardened material it is not possible to foresee any processing that will allow the dusting of the components in the environment; same considerations for the disposal of the hardened product. It is therefore reasonable to expect, in normal conditions of use, the impossibility for the operator to inhale any type of dust during the entire life cycle of the product. It is, however, recommended to adopt all the precautions in order that the product not deteriorate and in order to avoid the improbable possibility of dust formation hazardous for the human health. For further information see section 7 of the sheet. On the basis of available data, the product does not contain any PBT or vPvB in percentage greater than 0,1%.