Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
≤0.3
EC/CAS
4719-04-4
Name of the chemical
2,2′,2′′-(Hexahydro-1,3,5-triazine-1,3,5- triyl)triethanol
Concentration
≤0.3
General Information
Version
19
Revision date
2024-09-26
Product name
KOOL SEAL UV Resistant Black Patch & Coat
Manufacturer Name
KST Coatings
Emergency telephone
(216) 566-2917
Icons in SDS
Company Information
company name
KST Coatings
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H317, H350
Hazard statements
Code
Statements
H317
May cause an allergic skin reaction
Section 2
SECTION 2: Hazards identification
Ingredient(s) with unknown acute toxicity
42% (dermal), 42% (inhalation)
Signal word
Danger
Hazard statements
May cause an allergic skin reaction. May cause cancer.
Precautionary statements
General : Read label before use. Keep out of reach of children. If medical advice is needed, have product container or label at hand.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves, protective clothing and eye or face protection. Avoid breathing vapor. Contaminated work clothing must not be allowed out of the workplace.
Response
IF exposed or concerned: Get medical advice or attention. Wash contaminated clothing before reuse. IF ON SKIN: Wash with plenty of water. If skin irritation or rash occurs: Get medical advice or attention.
Storage
Store locked up.
Disposal
Dispose of contents and container in accordance with all local, regional, national and international regulations.
Supplemental label elements
WARNING: This product contains chemicals known to the State of California to cause cancer. Adequate ventilation required when sanding or abrading the dried film. If Adequate ventilation cannot be provided wear an approved particulate respirator (NIOSH approved). Follow respirator manufacturer's directions for respirator use. DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading or sanding of the dry film may release Crystalline Silica which has been shown to cause lung damage and cancer under long term exposure. Please refer to the SDS for additional information. Keep out of reach of children. Do not transfer contents to other containers for storage.
2.3 Other hazards
None known.
2.1 Classification of the substance or mixture
substance or mixture CARCINOGENICITY - Category 1A Percentage of the mixture consisting of ingredient(s) of unknown acute toxicity: 42% (dermal), 42% (inhalation)
