Note: Ingredients listed on restricted chemical lists
EC/CAS
7757-83-7
Name of the chemical
Sodium sulphite
Concentration
N/A
General Information
Revision date
2014-07-31
Product name
KODAK Rapid Selenium Toner
Product Synonyms
PCD 2667
1.2.1 Relevant identified uses
Toner. For industrial use only
supplier name
Kodak Alaris Inc.
Icons in SDS
Company Information
company name
Kodak Alaris Inc.
e-mail address of the competent person responsible for the Safety Data Sheet
EHS-Questions@Kodakalaris.com
Section 2
SECTION 2: Hazards identification
Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200: Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200:
Principle Routes of Exposure
Acute toxicity Category 4 Oral Skin sensitisation Category 1 -- Specific target organ toxicity - Category 2 -- repeated exposure
Contains
Ammonium thiosulphate (7783-18-8), Sodium sulphite (7757-83-7), Selenious acid, disodium salt (10102-18-8)
Hazard statements
May cause an allergic skin reaction. May cause damage to organs through prolonged or repeated exposure. (Central nervous system, Kidney, Liver.)
Prevention
Wear protective gloves. Do not breathe dust/ fume/ gas/ mist/ vapours/ spray. Wash thoroughly after handling. Do not eat, drink or smoke when using this product. Contaminated work clothing should not be allowed out of the workplace.
Response
Get medical advice/ attention if you feel unwell. IF ON SKIN Wash with plenty of soap and water. If skin irritation or rash occurs Get medical advice/ attention. IF SWALLOWED Call a POISON CENTER or doctor/ physician if you feel unwell. Rinse mouth. Wash contaminated clothing before reuse.
Disposal
Dispose of contents/container in accordance with local/regional/national/international regulation.
Other hazards which do not result in classification
Dried product residue can act as a reducing agent. HMIS III Hazard Ratings: Health - 2, Flammability - 1, Physical Hazard - 0 NFPA Hazard Ratings: Health - 3, Flammability - 1, Instability - 0 NOTE: HMIS III and NFPA 704 (2007) hazard indexes involve data review and interpretation that may vary among companies. They are intended only for rapid, general identification of the magnitude of the potential hazards. To adequately address safe handling, ALL information in this MSDS must be considered.