KODAK Rapid Fixer, Part B

SECTION 2: Hazards identification

Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200: Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200:

Principle Routes of Exposure

Corrosive to metals Category 1 -- Skin corrosion Category 1 -- Serious eye damage Category 1 --

Contains

Aluminium sulphate (10043-01-3), Sulphuric acid (7664-93-9)

Signal word

Danger

Hazard statements

May be corrosive to metals. Causes severe skin burns and eye damage

Prevention

Keep only in original container. Wear protective gloves/protective clothing/eye protection/face protection. Do not breathe dust/ fume/ gas/ mist/ vapours/ spray. Wash thoroughly after handling.

Response

Absorb spillage to prevent material damage. IF INHALED Remove victim to fresh air and keep at rest in a position comfortable for breathing. Immediately call a POISON CENTER or doctor/ physician. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. IF ON SKIN (or hair): Remove/ Take off immediately all contaminated clothing. Rinse skin with water/ shower. Wash contaminated clothing before reuse. IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.

Storage

Store in corrosive resistant container with resistant inliner

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulation. HMIS III Hazard Ratings: Health - 3, Flammability - 0, Physical Hazard - 0 NFPA Hazard Ratings: Health - 3, Flammability - 0, Instability - 0 NOTE: HMIS III and NFPA 704 (2007) hazard indexes involve data review and interpretation that may vary among companies. They are intended only for rapid, general identification of the magnitude of the potential hazards. To adequately address safe handling, ALL information in this MSDS must be considered.