KODAK EKTACOLOR SM PROCESSING UNIT, P1, Part A (Developer)

SECTION 2: Hazards identification

Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200: Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200:

Principle Routes of Exposure

Skin corrosion Category 2 -- Serious eye damage Category 2A -- Skin sensitisation Category 1 -- Specific target organ toxicity - Category 2 Oral single exposure Specific target organ toxicity - Category 2 Oral repeated exposure

Contains

Diethylene glycol (111-46-6), Sodium hydroxide (1310-73-2), 4-(N-ethyl-N-2- methanesulphonylaminoethyl)-2-methylphenylenediamine (92-09-1), N,N-diethylhydroxylamine (3710- 84-7)

Hazard statements

Causes skin irritation. Causes serious eye irritation. May cause an allergic skin reaction. May cause damage to organs if swallowed. (Kidney, Central nervous system.) May cause damage to organs through prolonged or repeated exposure if swallowed. (Liver.)

Prevention

Wear protective gloves/ eye protection/ face protection. Do not breathe dust/ fume/ gas/ mist/ vapours/ spray. Wash thoroughly after handling. Do not eat, drink or smoke when using this product. Contaminated work clothing should not be allowed out of the workplace.

Response

IF exposed or if you feel unwell Call a POISON CENTER or doctor/ physician. IF ON SKIN Wash with plenty of soap and water. If skin irritation or rash occurs Get medical advice/ attention. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/ attention. Take off contaminated clothing and wash before reuse.

Storage

Store in a well-ventilated place. Keep cool

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulation. HMIS III Hazard Ratings: Health - 2*, Flammability - 1, Physical Hazard - 0 NFPA Hazard Ratings: Health - 2, Flammability - 1, Instability - 0 NOTE: HMIS III and NFPA 704 (2007) hazard indexes involve data review and interpretation that may vary among companies. They are intended only for rapid, general identification of the magnitude of the potential hazards. To adequately address safe handling, ALL information in this MSDS must be considered.