KODAK EKTACOLOR RA DEVELOPER REPLENISHER, Part A

SECTION 2: Hazards identification

Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200: Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200:

Principle Routes of Exposure

Flammable liquids Category 4 -- Skin corrosion/irritation Category 2 -- Eye irritation Category 2A -- Specific target organ toxicity - Category 2 -- single exposure

Contains

Triethanolamine (102-71-6), N,N-diethylhydroxylamine (3710-84-7)

Hazard statements

Combustible liquid. Causes skin irritation. Causes serious eye irritation. May cause damage to organs. (Kidney, Liver.)

Prevention

Keep away from open flames/hot surfaces. - No smoking. Wear protective gloves/eye protection/face protection. Do not breathe dust/ fume/ gas/ mist/ vapours/ spray. Wash thoroughly after handling. Do not eat, drink or smoke when using this product.

Response

In case of fire, use water/water spray/water jet/carbon dioxide/sand/foam/alcohol resistant foam/chemical powder for extinction. IF exposed or if you feel unwell: Call a POISON CENTER or doctor/ physician. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/ attention. IF ON SKIN: Wash with plenty of soap and water. If skin irritation occurs: Get medical advice/ attention. Take off contaminated clothing and wash before reuse.

Storage

Store in a well-ventilated place. Keep cool

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulation.

Other hazards which do not result in classification

Heat sensitive - can decompose if heated. The physical-chemical properties of this material have not been fully investigated. HMIS III Hazard Ratings: Health - 2*, Flammability - 2, Physical Hazard - 1 NFPA Hazard Ratings: Health - 3, Flammability - 2, Instability - 1 NOTE: HMIS III and NFPA 704 (2007) hazard indexes involve data review and interpretation that may vary among companies. They are intended only for rapid, general identification of the magnitude of the potential hazards. To adequately address safe handling, ALL information in this MSDS must be considered.