Note: Ingredients listed on restricted chemical lists
EC/CAS
1310-58-3
Name of the chemical
potassium hydroxide
Concentration
N/A
General Information
Revision date
2013-12-19
Product name
KODAK EKTACOLOR RA Developer Replenisher, 12/55 RA-4, Part C
Product Synonyms
PCD 5980
1.2.1 Relevant identified uses
photographic processing chemical (developer/activator). For industrial use only
supplier name
Kodak Alaris Inc.
Icons in SDS
Company Information
company name
Kodak Alaris Inc.
e-mail address of the competent person responsible for the Safety Data Sheet
EHS-Questions@Kodakalaris.com
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200: Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200:
Principle Routes of Exposure
Target organs) Corrosive to metals Category 1 -- Skin corrosion Category 2 -- Serious eye damage Category 1 --
Contains
Potassium carbonate (584-08-7), Potassium hydroxide (1310-58-3)
Signal word
Danger
Hazard statements
May be corrosive to metals. Causes skin irritation. Causes serious eye damage
Prevention
Keep only in original container. Wear protective gloves/ eye protection/ face protection. Wash thoroughly after handling.
Response
Immediately call a POISON CENTER or doctor/ physician. IF ON SKIN Wash with plenty of soap and water. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Take off contaminated clothing and wash before reuse. Absorb spillage to prevent material damage.
Storage
Store in corrosive resistant container with resistant inliner
Disposal
Dispose of contents/container in accordance with local/regional/national/international regulation. HMIS III Hazard Ratings: Health - 2, Flammability - 0, Physical Hazard - 0 NFPA Hazard Ratings: Health - 3, Flammability - 0, Instability - 0 NOTE: HMIS III and NFPA 704 (2007) hazard indexes involve data review and interpretation that may vary among companies. They are intended only for rapid, general identification of the magnitude of the potential hazards. To adequately address safe handling, ALL information in this MSDS must be considered.
