KODAK EKTACOLOR RA Bleach-Fix and Replenisher, Part B

Kodak Alaris Inc.

Revision date : 2015-03-27

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.
GHS05 GHS07 GHS08
Health risk rating 5
Safety risk rating 5
Environmental risk rating 5

Note: Ingredients listed on restricted chemical lists

EC/CAS

7732-18-5

Name of the chemical

Water, distilled, conductivity or of similar purity H2O

Concentration

N/A

EC/CAS

64-19-7

Name of the chemical

acetic acid

Concentration

N/A

General Information

Revision date

2015-03-27

Product name

KODAK EKTACOLOR RA Bleach-Fix and Replenisher, Part B

Product Synonyms

PCD 5777

1.2.1 Relevant identified uses

photographic processing chemical (bleach/bleach fixer). For industrial use only

supplier name

Kodak Alaris Inc.

Emergency telephone

1-800-424-9300 or +1 703-527-3887

Icons in SDS

Company Information

company name

Kodak Alaris Inc.

e-mail address of the competent person responsible for the Safety Data Sheet

EHS-Questions@Kodakalaris.com

GHS Information

Signal word

Danger

Section 2

SECTION 2: Hazards identification

Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200: Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200:

Principle Routes of Exposure

Corrosive to metals Category 1 -- Eye irritation Category 2A -- Skin irritation Category 2 -- Respiratory sensitisation Category 1 --

Contains

Ammonium ferric ethylenediaminetetraacetic acid (21265-50-9), Acetic acid (64-19-7)

Signal word

Danger

Hazard statements

May be corrosive to metals. Causes serious eye irritation. Causes skin irritation May cause allergy or asthma symptoms or breathing difficulties if inhaled.

Prevention

Keep only in original container. In case of inadequate ventilation wear respiratory protection. Wear protective gloves/ eye protection/ face protection. Wash hands thoroughly after handling. Avoid breathing dust/ fume/ gas/ mist/ vapours/ spray.

Response

IF INHALED If breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for breathing. If experiencing respiratory symptoms: Call a POISON CENTER or doctor/ physician. IF ON SKIN Wash with plenty of soap and water. If skin irritation occurs Get medical advice/ attention. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER or doctor/ physician. If eye irritation persists: Get medical advice/ attention. Take off contaminated clothing and wash it before reuse. Absorb spillage to prevent material damage.

Storage

Store in corrosive resistant container with resistant inliner

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulation. HMIS III Hazard Ratings: Health - 2, Flammability - 1, Physical Hazard - 1 NFPA Hazard Ratings: Health - 2, Flammability - 1, Instability - 1 NOTE: HMIS III and NFPA 704 (2007) hazard indexes involve data review and interpretation that may vary among companies. They are intended only for rapid, general identification of the magnitude of the potential hazards. To adequately address safe handling, ALL information in this MSDS must be considered.

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.