Indicator Stop Bath, Working Solution

SECTION 2: Hazards identification

Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200: Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200:

Principle Routes of Exposure

Skin corrosion/irritation Category 2 -- Serious eye damage/eye irritation Category 1 -- Respiratory sensitisation Category 1 --

Contains

Acetic acid (64-19-7)

Signal word

Danger

Hazard statements

Causes skin irritation. Causes serious eye damage. May cause allergy or asthma symptoms or breathing difficulties if inhaled.

Prevention

Wear protective gloves/ eye protection/ face protection. In case of inadequate ventilation wear respiratory protection. Avoid breathing dust/ fume/ gas/ mist/ vapours/ spray. Wash thoroughly after handling. Do not eat, drink or smoke when using this product.

Response

IF INHALED If breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for breathing. If experiencing respiratory symptoms: Call a POISON CENTER or doctor/ physician. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER or doctor/ physician. IF ON SKIN Wash with plenty of soap and water. If skin irritation occurs Get medical advice/ attention. Take off contaminated clothing and wash before reuse.

Storage

Store in a well-ventilated place. Keep cool

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulation. HMIS III Hazard Ratings: Health - 2, Flammability - 1, Physical Hazard - 0 NFPA Hazard Ratings: Health - 3, Flammability - 1, Instability - 0 NOTE: HMIS III and NFPA 704 (2007) hazard indexes involve data review and interpretation that may vary among companies. They are intended only for rapid, general identification of the magnitude of the potential hazards. To adequately address safe handling, ALL information in this MSDS must be considered.