E6 Color Developer Replenisher, Part B

SECTION 2: Hazards identification

Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200: Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200:

Principle Routes of Exposure

Corrosive to metals Category 1 -- Acute toxicity Category 4 Oral Skin corrosion Category 2 -- Serious eye damage Category 2A -- Skin sensitisation Category 1 -- Specific target organ toxicity - Category 2 -- single exposure

Contains

4-(N-ethyl-N-2-methanesulphonylaminoethyl)-2-methylphenylenediamine sesquisulphate monohydrate (25646-71-3), 2,2-Ethylenedithiodiethanol (5244-34-8), Sodium sulphite (7757-83-7)

Hazard statements

May be corrosive to metals. Harmful if swallowed. Causes skin irritation. Causes serious eye irritation. May cause an allergic skin reaction. May cause damage to organs. (Kidney.)

Prevention

Keep only in original container. Wear protective gloves/ eye protection/ face protection. Do not breathe dust/ fume/ gas/ mist/ vapours/ spray. Wash thoroughly after handling. Do not eat, drink or smoke when using this product. Contaminated work clothing should not be allowed out of the workplace.

Response

IF exposed or if you feel unwell Call a POISON CENTER or doctor/ physician. IF ON SKIN Wash with plenty of soap and water. If skin irritation or rash occurs Get medical advice/ attention. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Take off contaminated clothing and wash before reuse. Absorb spillage to prevent material damage. Rinse mouth.

Storage

Store in a well-ventilated place. Keep container tightly closed

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulation.

Other hazards which do not result in classification

Can decompose at elevated temperatures. MAY LIBERATE SULFUR DIOXIDE HMIS III Hazard Ratings: Health - 2*, Flammability - 0, Physical Hazard - 0 NFPA Hazard Ratings: Health - 3, Flammability - 0, Instability - 0 NOTE: HMIS III and NFPA 704 (2007) hazard indexes involve data review and interpretation that may vary among companies. They are intended only for rapid, general identification of the magnitude of the potential hazards. To adequately address safe handling, ALL information in this MSDS must be considered.